You will need a metric Allen wrench (7 mm).Jack up passenger side and place jack stand. Remove wheel. Take a screwdriver and work it in between brake pad and rotor. Once done, apply steady pressure on brake pad until you push the caliper piston as far in (toward engine) as it will go. You will need to remove caliper bolts. They are on the back of the caliper at top and bottom. Place Allen wrench in each bolt and turn wrench towards front of vehicle to remove. Once removed, remove caliper with brake pads inside. Match new brake pads with old and put new pads in like you removed the old pads. Place new pads and caliper back on vehicle and replace caliper bolts. If caliper and new pads do not slide easily back in place,you may need to get a large c-clamp and push piston back in caliper a little more. After you get caliper back on and tightened, get in car and pump your brake pedal until it is hard to push. This resets the brake pads. Replace wheel and your done!!
Anti-rattle clips not installed properly
Replacing disc brakes can be a tricky task. First, you must make sure they are cool enough to touch, then bleed them and take apart the brakes. You can put new pads and discs on to finish the job.
Just pads? approx. $30-50 If it needs rotors? Probably $50 ea. If it needs calipers? Probably $50 ea.
It just cost me $735 from a mechanic I have always trusted. I have a 2001 L300.
The brake shoes may be out of adjustment causing the shoes to contact the drums prematurely. You could have a proportiong valve issue, but try adjusting the rear brakes first.
How do you replace front breaks on 2001 Hyundai acce t
2001 forerunner front brake replacement
how to replace break pads on 2001 4runner
What size wrench do you need to change the front brakes on a 2001 dodge durango?"
http://www.carquest.com/techbulletins/brakes/2001/CQB%2001-10.pdf
There is no adjustment on disc brakes. Replace them.
Normally you do !
I have been an auto tech for 20 years! The entire headlight assembly unscrews out of the front of the bumper. press on the headlight from the front and turn it counterclockwise to release it from the bezel!
on the front lower left side of the engine
I have a 2004 and have had to replace transmission, and replace brakes a lot
Show me how to replace the camshaft position sensor on a 2000 volkswagen new beetle
Open the hood. On the headlight housing you will see a locking cam. Depress and release. The whole assy will be pulled from the front of the car. Once out you will see how to replace the bulb(s)