both are done much the same way.just make sure all torque settings etc are for whichever car you are working on
The carbureted 86-93 Mazda trucks do have a catalytic converter off the exhaust manifold, whereas the fuel injected version does not. If you have the carbed version, and you put on a header (like a pacesetter) to replace the exhaust manifold, then you will get rid of 1 catalytic converter.
I have a 88 B2200 and i did a 318 V8 swap. Wasnt hard. Added coils to front. Welded in the mounts and changed nothing else. Fast but managable.
Overheating will blow the head gasket and/or warp the cylinder head. In the worst scenario, the cylinder head probably cracked and allowing water to get into the piston(s) which is probably why the vehicle won't start. If you are going to do the work yourself, be sure and take the cylinder head to a machine shop and have it pressure tested for leaks and also have it resurfaced.
Usually the crankshaft is made of harder metal than the bolt, so you should be able to just replace the bolt. But who knows for certain until you try.
Not to be smart but it is where you insert the key to start the vehicle!!!!!.If you have issues with the key cylinder not working properly like dome light,door buzzer or radio not coming on or staying on with the truck running you need to replace the ignition.It will cost on average 130.00 from auto zone or advance auto parts and not hard to replace.Not really sure what you want to know exactly but,figure the issue is one the items listed staying on or not coming on with the vehicle running like the door buzzer, no radio ,or even the fan switch for the heat or air condition.
replace head gasket
How do you replace fuel pump 92 Mazda pick up B2200?
very carefully
The intake & exhaust manifold must be removed, then the head is remove. Head inspected for cracks and warpage, all gaskets replaced and all parts reinstalled.
No
where is the fuel pump on a 89 Mazda b2200
Who is a valve calibration for mazda b2200 1988
where is the EGR valve on a 1989 mazda b2200
The 1992 Mazda B2200 will hold close to 17 gallons of gas. The 1992 Mazda B2200 is a four-cylinder vehicle.
yes you can its a straight swap you don't even have to change engine mounts
A Mazda B2200 engine with carburetor has 85 horsepower, and with fuel-injection has 105 horsepower.
where is the ignition module located on a 1988 Mazda b2200