It depends on what year. For 72 and earlier (in the dash) follow this. 1. Turn ignition switch to off position and leave the key in the switch. 2. Disconnect the battery. 3. Take a small dia. paper clip and insert it into the small hole in the face of the ignition switch. You will feel a small button that you depress. 4. While depressing the button, turn the key to the accessory position (counter clockwise) and using the key remove the cylinder. 5. You can now remove the bezel by unscrewing it CCW. 6. This will allow you to remove the ignition switch from the dash and disconnect the wire harness plug from the rear of the switch. I hope this helps someone. From an old gear head.
it cost 1500 dollars to replace my tranny at the local tranny shop
A bad ignition switch can shut down a vehicle's electrical system. Ignition switches have been the cause of a major recall by General Motors.
assuming the battery and cables are good and connected....check the ignition switch..:)
More than likely because of a short. its probably a shorted ignition switch
Dead battery? Loose or dirty battery cables? Bad starter solenoid? Bad starter? Neutral switch?
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
1995 ford 350 1 ton box truck ignition replacement
It is just under the front of the dash, But on the top side of the steering shaft under the dash.
how to remove cover to replace ignition lock cylinder and what type of tools do i need
Removing the ignition key switch from a 1998 Chevrolet truck is a relatively straightforward process. Before beginning it is important to make sure that the truck is off and the battery has been disconnected. To begin you will need to remove the steering wheel by first removing the center wheel nut with a 12" socket and wrench. You should then use a steering wheel puller to remove the wheel. Once the wheel is removed the ignition key switch will be visible in the center of the steering wheel. To remove the ignition key switch you will need to remove the retaining clip and then unscrew the bolts securing the switch in place. After the bolts have been removed the switch can be removed and replaced with the new one.
You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
how is it to replace fuel pump on 2000 Chevrolet truck
call a lock smith .
the truck will not crank or anything with the key it wont even starter when you ark the starter all it does is whizz