A bad ignition switch can shut down a vehicle's electrical system. Ignition switches have been the cause of a major recall by General Motors.
yes
Generally the problem is either a defective neutral safety switch or a bad ignition switch (not ignition key lock).
Yeah sure, its that thing you stick your key into to start it.
I hav just purchased a 58 Chevy apache and are having the same problem. I did find a site that displays a complete diagraham for the entire ststem includingthe ignition switch. The site is http://www.classicchevytrucks.20m.com/cgi-binwiring.jpg Good luck with the changeover wspringerjr@yahoo.com
The large red wire is the battery or hot wire.
NO, there is no coalition between the ignition switch and the transmission. The ignition switch does 2 things. Turns on power to the electrical system for the engine and supplies power to the starter during start-up.
Starter relay protects the ignition switch from excessive electrical draw.
How do i change the ignition switch in a 1988 Chevy camaro
how to replace an ignition switch for 2005 chevy equinox
How to remove ignition switch
Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Begin by removing the retaining ring at the top of your 1992 Chevy ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
Remove the retaining ring at the top of your 1994 Chevy Corsica ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.
The 1966 Chevy Impala ignition switch can be removed by loosening the retaining ring at the top of the ignition switch. Remove the wiring harness. Reverse the process to install the new ignition switch.