Remove 2 small u-bolts from rear end yoke
Pry drive shaft out of yoke
Slide front end of drive shaft off front splines
As floor coating or paint, not to actually replace the metal.
Only one. The filter is integrated into the fuel pump module, located inside the fuel tank. To replace the filter, you must replace the entire fuel pump module. To replace that module, you must first either remove the fuel tank or the truck box.
check the exhaust line one of the heat shield (metal plate between the pipe and the cab) migth be loose
yes the s10s were the same from 94 to 04 exept for the interior and grill change in 1997-1998
header board is a the board on the front of the trailer, or the board that is on the tractor behind the cab/sleeper. this is made of metal and is to prevent the load on trailer coming thru the cab in the event an accident or other emergency
if the play is in driveshaft, replace u joints. if the play is actually in the diff, remove driveshaft and tighten pinion bearing.
A worn out Universal joint in the rear driveshaft.
In a 1999 Toyota Tacoma, the front seats are typically bucket seats, and the rear seating configuration depends on whether the truck is a standard cab, extended cab, or crew cab. The standard cab usually has no rear seats, while the extended cab can accommodate jump seats. Replacement seats must fit the mounting points and dimensions of the Tacoma, so aftermarket options designed for this model year can be considered for upgrades or replacements. Always check compatibility for specific seat models and configurations.
http://www.customtacos.com/tech/index.php?article=303
More than likely your heater core is leaking. The only fix is to replace it.
The 1999 Toyota Tacoma standard cab typically comes with 6.5-inch speakers in the front doors. The rear area does not have factory speakers, as standard cab models are designed with limited rear space. If you're considering upgrades, it's advisable to check the specific configuration of your truck, as aftermarket installations may vary.
To replace the carrier bearing on a 1994 Toyota SR5 X-Cab pickup, first, elevate the vehicle securely and remove the driveshaft from the rear differential and the transmission. Then, remove the old carrier bearing by unbolting it from its mount. Install the new carrier bearing in the same position, ensuring it is properly aligned, and reattach the driveshaft to both ends. Finally, check for proper alignment and secure all bolts before lowering the vehicle.
You are asking about 2 different things. A double cab is describing the type of cab such as regular cab and access cab describe their cabs. PreRunner is a 2wd Tacoma that has the look and suspension of a 4wd. You can get a PreRunner in an Access cab as well.
Pay someone else to do it!
On the basis of seat belts, three passengers plus driver in the standard cab and four plus driver in the extended cab. www.toyota.com/tacoma/
I had this problem, the smell was coming from the sleeve over the shifter in a manual Toyota tacoma. My friend, a qualified mechanic, said it was probably a failed seal between the cab and belly of the vehicle that allowed oil burning off the exhaust from the engine, into the cab.
No, it will not fit.