answersLogoWhite

0

Directions to do so are listed in the drivers manual.

Key on, engine off. Press the gas pedal down three times in five seconds.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you reset the maintenance light after an oil change on a 2010 Chrysler Sebring?

The oil change light is reset by Key on, engine off. Press the gas pedal to the floor three times. Cycle key off and on.


How to reset service interval A on a 2010 Mercedes E350?

To reset the service interval A on a 2010 Mercedes E350, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds. After this, turn the ignition off, then back on. The service interval indicator should now be reset.


How do you reset the change oil indicator on a 2010 Chrysler Sebring?

Key on, engine off. Press the gas pedal to the floor three times in ten seconds.


How do you reset the oil change indicator on a 2010 Chrysler town and country?

Turn the ignition key to the ON position (don't start the engine) and pump the accelerator three times within 10 seconds. Turn the key to OFF.


How can you reset the tire pressure system for your 2010 Chrysler 300?

The system will reset itself after driving if all tires are at the correct pressure (check the label on the driver's door) and there are no sensor problems.


How to reset headrest 2010 chrysler town?

If it has the active restraint headrests that pop forward in a crash, the dealers scan tool is required.


What size engine does the 2010 Chrysler 300 have?

The 2010 Chrysler 300 has a V6 engine.


How many valves does the 2010 Chrysler 300 have?

The 2010 Chrysler 300 has 24 valves.


What kind of transmission does the 2010 Chrysler 300 have?

The 2010 Chrysler 300 has a 4-speed automatic.


Is the 2010 Chrysler 300 electric or gas?

The 2010 Chrysler 300 is a gas-powered vehicle.


How do you reset a change oil light on a 2010 Nissan Altima?

You can reset the change oil light on your 2010 Nissan Ultima by going to the oil life display. When the oil life display is illuminated hold in the checkmark button until the oil life goes to 100 percent.


How do you reset oil change light 2010 Nissan Murano?

To reset the oil change light on a 2010 Nissan Murano, first, turn the ignition key to the "On" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn the ignition off and start the engine to ensure the oil change light is reset. If the light remains, repeat the process.