While it is still setting up, it can be carved to get a general shape, then it is sanded. Apply in thin layers up to 1/4 inch for large areas. To fill in large gaps or to build shapes it can be put on a sheet of plastic or cardboard and held in place until it sets. There are epoxy fillers for bumpers, but if there is much damage it is usually better to replace the cover.
A vacuum former is a plastics melter which has a springy bed and on it. Place the shape desired on the platform and the plastic sheet on the side opposite from the vacuum inlet. The plastic will be heated and pressed over the shape.Specific safety instructions should be followed depending on the model used.
obviously because it's light and safe. Who would want to play with a STEEL-IRON doll? If you drop it, it'll kill your toe!!! What about wood? Well, you get splinters. HOPE THIS HELPS! Plastic can be injected into molds, in any shape you can imagine. To do the same thing in wood would cost a small fortune for just one toy. A plastic injected molded toy can be mass produced in great numbers in a very short time, bringing huge economies to the toy manufacturing business... and occasionally to the toy-buying public.
sturctural shape is how the top half of an egg looks strange but the shape puts equal amounts of weight at almostevery point in the structure in sort of a ring shape. therefor relating structural shape to strength. by cat
Earth's shape is oblate spheroid.
her body shape and waist line is 33-23-34
cut the shape you need out of foam. sand it to desired smoothness, wrap in masking tape, got to the local craft store and or wal-mart and buy fleece material and some fiberglass resin. cover mold in fleece soak with activated resin, wait to dry. then apply bondo. paint as desired or cover in carpet
Use a band saw and cut out the section u want removed. Then cut the section u removed so that the peice lower part of the removed will fit correctly back to the base of the hat. Use fiberglass bondo and sandpaper to re shape and form the harddhat. Paint and there u go. You will learn more little tricks the more u fo it. Tip...use a old hat for your first time.
it means that plastic can easily change shape. You can easily change the shape of a plastic object.
Not necessarily. "Plastic" in this sense means "related to shape".
plastic
to form the shape of the plastic
curve it into shape with thermosoftning plastic
A plastic bottle shape.
a plastic pen is made out of a special type of plastic that is moulded to the shape of a pen! :)
melt plastic from a plastic melter gun shape it into a cylinder
a long piece of plastic
Machines to use can be saw machines of that variety o shape the plastic by moving it onto the electric machined cuter!