Yake the console out and clean the trans and brake linkage.
Around that time of production, these cars were coming out with safety devices, so the car couldn't be put into gear without first applying the brake. Most of these devices work off of vacuum. Your problem will involve a vacuum switch located on the brake pedal.
one lever in a bathroom is a toilet lever hope that helps:)
Lever House was created in 1952.
A lever in a bathroom can flush your toilet or open a faucet.
no
the hand lever is the part of microscope.... the microscope need to see the small things or viruses....
sledge hammer, crow bar, locksmith.
Pull the turn signal lever toward you. Do the same to turn them off.
It is located on the Driver side, underneath the dash board, look around where you pull the lever for opening the hood.
You will find the key code like most 90 models honda. where the trunk lever is. first you remove the cover and pull out the key cylinder and imprinted on the side will be the key code.
You can pull on the cable for the fuel door. The cable is located in the trunk behind the side panel.
in the center of the console located straight down under the radio. remove the center plastic door or plate, facing the gearshift lever.
lever pulled out, having trouble getting the lever locked back in place
Find the Shifter Lock Override Slot. It'll be under a cap. Remove the cap, push down on the lever inside with a nail file or something, and shift into neutral.
You're not locked out until you pull the lever : go back in and pull it.
If the lever that is supposed to hold the column locked in position no longer works get it repaired ASAP. This is a dangerouls condition in which to drive it. There are no owner-fixes for this problem.
Location of '96 Honda Accord DLC portBeneath the radio, remove the ashtray, and look into the well below. You will see a Diagnostic Port, or you will see a plastic cover over it. You may have to move the shifter to LOW to access the area well enough to see it. Before you do, be sure to set the parking brake securely. You will need to turn the key to the "ACC" or "RUN" position to release the auto shift lever. Alternately you can insert your key into the shift lock release slot next to the shift lever.
It is for the tilt steering wheel. Pull it out and you can adjust your steering wheel. Push it back in when it is set at optimum for you