How do you turn a camera into a taser?

Answer 1

Making a tazer is surprisingly easy. All you have to do is buy a disposable camera with a flash. It can be just about any type. All you have to do is take the paper or cardboard off the camera then you should be left with a plastic casing. you might see some little hook like things. You have to undo these. Its a little tricky but it's possible. after that you will be holding the actual device. Now you'll have to look for the capacitor. It's probably near the flash or on the side of the camera. Be careful and do not touch this. Now you just have to find the flash button. Press this and you should hear a sound. If you do then if someone touches the capacitor while your holding the button it should shock them. Be careful because sometimes the capacitor can still shock you even if there's no batteries in it. I f the capacitor stops working you can make them touch the green panel and this will have the same effect as the capacitor. Be careful because my cousin did this and it turned a little part of his finger black. It's cheap but effective.

Answer 2

Well if you dont want to kill anybody, unsolder the capacitor( the cylinder black round thing) and resolder 2 wires in the 2 holes. Now the current is not infinite. wrap the whole thing with electrical tape except for the 2 wires, put a battery in, press the flash button, and touch the 2 wires. It will feel like those prankster shock pen and those shock gum.

Answer 3

It is very very easy. First make sure the film is at 0 photos left. For Kodak brands, once all the photos are used, it automatically becomes sealed so you can take the camera apart without damaging the photo. Take off the sealed photo container. Once you opened, you will find a battery. On the plastic cover that covers the battery, cut it off so you can replace batteries. Make sure you write down the + and - terminals so it will work. keep the cover closed at all times. Make sure you didn't charge it. If you charged the flash, make it flash. Also you will find that the scrolly thing will be connected to a few gears. You have to wind that using the gear things. Now you have to drill 2 holes where the capacitor is. Solder 2 wires connecting to the + part of the capacitor, and one wire connecting to the - side. Now MAKE SURE THEY DON'T TOUCH. Now put it back together, charge the flash, and put the 2 wires to someone's arm or legs, or butt.(NOT THEIR BODY OR THEY WILL DIE) their heart will not take that much power. You can try it on your finger. It will feel numb and your whole arm will be numb and will tingle for a few mins. The voltage is 550 volts and 0.6 amps!!!
I am not responsible for any harm you do with your taser. just saying
.

Answer 4

You can make a low power stun device, but it won't do much more than startle someone. Definitely not a TASER stun device.