To use the cruise control on the PT Cruiser, turn the cruise control on in the steering wheel. Accelerate to the desired speed and push in the end of the left turn signal knob. The cruise control should then control the speed. To take the car out of cruise control, a person can tap the brake.
It is a sensor that reads the rotational position of the camshaft. The engine computer uses that to control ignition and fuel timing.
A person can get a 2004 PT Cruiser engine diagram from a Chrysler dealership. An auto parts store also may have a copy of the diagram for customers.
Did you ever have a coolant leak?
The led light in the window switch is not replaceable. It is only serviced with the entire switch.
The gas cap warning light on a 2008 Chrysler PT Cruiser means that the fuel cap may be loose, missing, or not properly sealed. This can cause a leak in the fuel system, which affects the vehicle’s evaporative emissions system.
You can add a factory unit or aftermarket.
To activate the cruise control in a 2008 PT Cruiser, first accelerate to your desired speed. Once you're at that speed, press the "SET" button on the cruise control stalk located on the steering wheel. To increase or decrease speed, use the "ACCEL" or "DECEL" buttons, and to deactivate the cruise control, either press the "CANCEL" button or tap the brake pedal. To resume your set speed, press the "RESUME" button.
Yes, factory and aftermarket versions were available.
You can find the crusier control on the back of the right side of the stering wheel but not to far back, if you have cruise control. The cruise control is an opition; standard on the touring,limited,and GT edition.
There isn't a separate fuse for the cruise. It is powered by the engine computer. If the engine runs, the fuse is ok.
push in on the button on the end of the cruise control lever on the right side of your steering wheel.
There isn't a separate fuse for the cruise control. The system is powered by the engine computer. If the car runs, it is not a fuse problem.
use a ball joint separator
In the engine control module.
In the engine compartment
5w30
All model years of the PT cruiser will use R134a refrigerant in their air conditioning system, and PAG compressor oil.