It should work ok if the wire for the tach under the hood is connected and I don't remember which one it is.
Front drivers side sensor on crossover exaust pipe needs replaced. Note: use a socket made for oxogon sensors. Use anti seize if it's not on the new one when installing. After your done disconect neg. terminal of battery for 30sec. This should clear the code.
bad battery or loose battery cable
on the side of the fuse panel under the hood next to the battery.
Extremely difficult, and without a donor vehicle for parts, cost prohibitive. Sell this one and buy a 4wd. You will be money and time ahead.
Btc 2004 merit of fmale in Saharanpur
On the instrument cluster.
The instrument cluster is also the body computer.
You have to replace the instrument cluster in most cases.
To remove the instrument cluster from a 2004 Isuzu Ascender, first, disconnect the negative battery cable to ensure safety. Then, remove the trim panel surrounding the cluster by unscrewing any visible screws and gently prying it off. Next, unscrew the cluster mounting screws, carefully pull the cluster out, and disconnect the wiring harnesses at the back. Be sure to handle the cluster and wiring with care to avoid damage.
As per www.totalrecallinfo.com there is only a recall on tires for this model.
the speedometer in my 2004 Montana kept sticking. showing I was going 50mph when I was sitting still. the instrument cluster turned out to be at fault and had to replace the entire cluster as it is one unit.
I will be able to answer that questions in 2 weeks. I have a 2001 in Florida that needs repair and I have a 2004 in Ohio. I recently replaced and repaired instrument cluster in the 2004, so when I get to Florida, I wll try to trade the parts out.
That is were all your gauges and lights that come on when you turn the key on is. You look at it all the time to see how fast you are going.
If it's an automatic; Go to subaruoutback.org, click on Forums, under General > Do-It-Yourself Illustrated Guide > Replacing Lights on the Instrument Cluster.
The stepper motor is located in the instrument cluster. The stepper motor is what turns the needles in all the gauges.
Grab the top of the instrument cluster surround and pull towards you. It should pop right out. You now have exposed the instrument cluster. There are two screws on each side. Unscrew them and pull the cluster out. On the back side you will see the light sockets. Twist the one that is bad to the left and pull out the socket. pull out bulb and replace.
Wiper control is a joint effort between the instrument cluster and the TIPM (the computer that is oart of the under hood fuse box).Wiper control is a joint effort between the instrument cluster and the TIPM (the computer that is oart of the under hood fuse box).