Have a look at the clean up on the tin of paint, you will have your answer there, water clean up is waterbased, turps is oil based.
Paint thinner is nearly alwys used in oil based paints. If you mix it with mosts acrylic paint the paints it will be ruined - unless of course you have a solvent based acrylic - such as a thermoplastic acrylic.
If the base coat used in your project is water base then yes, you bet you can. If there is any chance that the base coat used was an oil base paint then you cannot paint directly over it. The acrylic enamel will not adhere to the oil base paint and will begin to peel off as soon as it is dry. In which case a coat of primer is in order.
No, it's not a latex base.
From a paint contractor in arizona. Yes you can sand good enough to break the glaze. and than by a good latex enamel paint and give 2ea. coats. with time to dry between coats.
yes u can use clear coat on ur enamel paint but first u hav to put primer then paint coats two - three coats depending on the requirements and then apply the clear coat single or double as required and most important thing is drying time shud be given in between each coats.
Paint thinner is nearly alwys used in oil based paints. If you mix it with mosts acrylic paint the paints it will be ruined - unless of course you have a solvent based acrylic - such as a thermoplastic acrylic.
Any paint that has the word 'acrylic' in the title is usually water based.
I think acrylic waterbase is hydrophilic whilst acrylic polymer paint is hydrophobic
Base is the main constituent of paints, ie synthetic polymers such as acrylic, vinyl acrylic, styrene acrylic, etc. as binders.[
use white nail polish then put a clear base on them
Lacquer can cause the paint to bubble or crack due to the very hot solvent that is a part of lacquer. If you want a clear coat over paint, a better choice is spar varnish over oil base paint and arcylic urethane over latex.
If the base coat used in your project is water base then yes, you bet you can. If there is any chance that the base coat used was an oil base paint then you cannot paint directly over it. The acrylic enamel will not adhere to the oil base paint and will begin to peel off as soon as it is dry. In which case a coat of primer is in order.
The base layer is polycarbonate plastic. Then an aluminium layer is sandwiched between this base layer and a protective (clear) acrylic coating.
No, it's not a latex base.
From a paint contractor in arizona. Yes you can sand good enough to break the glaze. and than by a good latex enamel paint and give 2ea. coats. with time to dry between coats.
No it will cause big problems. You should sand down to paint before adding a new coat of clearcoatAnswer: There is nothing wrong with putting a new coat of clear over old, as long as it is well sanded , and the underlying clearcoat is in sound condition. It is necessary to do it when spot- repairing a clear -over- base metallic paintjob.
black blue