0
Is it common for a new Ford rim to have had welding done around the circumference?
Wiki User
∙ 8y ago
If the rim is on a new car, no that is not common. Take it back and ask to see the manager or complain to the company.
if the people at the tyre service are sure that it is not the original welding on the rim then it is dangerous ,as it is illegal to repair any damaged rim because it creates a weak point.any reputable car dealer would have replaced the rim without question,if yours wont then take them to consumer affairs
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How change automatic transmission to manual ford bronco?
To change from an automatic to manual transmission in a Ford Bronco, you will have to fine a transmission that bolts up to the engine. The transmission mounts have to be changed. The shifter has to be changed along with adding an entire clutch system including a pedal. This will require brackets, drilling in the firewall and possibly welding under the dash.
Could anyone tell you what makes the rear heat in a 92 ford aerostar blow cold when the front works fine?
It's just a problem with your heater core, there's maybe debris that blocked it, and heat is working proprly? It's quite like a small radiator, it's not a piece of cake to change it, cause it will require welding, you've got a ford, Take it to the mechanic
Why is your ford courier truck not idling?
idle solinoid is broken or the power wire is not powered or pluged in. common on those carbys
How much does it cost to recharge air conditioner on 1993 ford van?
If no parts are needed probably around
What would cause a 1996 ford explorer stalls and hard to start not always but most of the time?
There are several things that can cause your 1996 Ford Explorer to stall in start hard. The most common cause is a fuel pump that is going bad.
Can you put 22 wheels on a 1993 Ford Explorer?
shure start welding axles and streching the frame......
How do you replace a Ford Fiesta front wing?
If it is after 1995 mark 4 it is easy bolt on, if earlier it needs cuttting and welding
Where can one find the Ford sign symbol?
You can find it on any car produced by Ford. Also on buildings which are used by the company. It is a very common symbol which you will find all around the world.
What type are the smaller lights on the bottom of a 1998 Ford Explorer?
The 560x series designed by sir hendy. These are usually around a 56 inch circumference and a chrome colour. They are a 15 watt and sometimes go up to 25 watts. The ford explorer, however is an exception since its a mega 65watts!
What Ford car 9 inch will fit under Chevy s 10?
Any one you want to use but not without fabrication/welding.
Is there a Rack and pinion steering conversion for a 61 Ford Galaxy?
Yes, there is a kit made by Wurth It Designs for 57-64 Ford Galaxie's. This kit is a direct bolt in and requires no cutting, welding, or fabrication.
There is a pool of water pool in the boot of my ford focus is this a common occurrence?
the seals around the boot might have a crack in them,letting in rain,it happened ,when i had my escort.
Did Henry ford create the car the train and the boat?
THE CAR, common Ford.
Is Ford Taurus a common or proper noun?
common and proper
What was a common car in the 1930's?
The Ford Model "A" was very common in the USA.
What is the price range of new Ford Transit Vans?
Ford transit vans are common for those who frequently have to drive commercially for business. Currently, the 2013 model of these vans range in price from around $22 to 28 thousand USD.
What do Chevy and ford have in common?
they are both cars
