0
What else can I help you with?
What year doors will fit 1968 2 dr dodge dart?
I,m pretty sure 69 will fit and possibly 67. all years 1967-1976 will fit- 1967-72 have the metal inside tops and vent window- 1973up are plastic w/o vent window but will bolt up
1972 dodge dart with a 1976 block 360 in it the car originally was a 318 car what you have recently noticed is that the center link is rubbing on the oil pan when the steering is turned to t?
Did you use the 318 oil pan????? If not that's why!!!!!The blocks the same width&height.....I have to disagree. I'm doing a conversion on my 67 gt dart that had a 225 slant in it. I'm putting a 360 in it and found that the main caps are different on a 360 than a 318. You have to find a pass. car 360 pan to make it work.Also make sure the motor mounts have not failed allowing the engine to drop lower.
Will a 1973 dodge dart fender fit a 1972 Plymouth valiant both are 2 door cars?
no 73 fenders are different you can use 68 or 69 fenders but there is a small difference in 67 there was no park light is 68 there was a round one up near the body line and in 69 there was a light near the front bottom that was the only difference to use a 68 or 69 fender all you have to do is fill in the light holes I had a 1969 Dart (2 DR HT) and replaced the left front fender with one from a 1967 (?, 2 DR GT). Besides the side light mentioned, the front surface where the headlight brackets attach was further forward. I beat the surface back with a sledgehammer and drilled holes for my headlight brackets. With the front bezel on it looked fine and the external sheet metal was the same. 73, No. 67-72 are the same as far as mounting. But 70+ had a different front end.
Will 1967 dodge darts headers work on a 1966 dodge dart for a 360 engine swap?
I believe they should work as I think the 66 and 67 had the same body style. They will not work. If you research the TTI headers (though expensive) it will show you that the headers for the 318/340/360 are rather narrow when used for the 63-66 A-Body, when you look for the 67-72 A-Body you will see they have a much larger outward sweep thus needed much more room within the fender well. I have been beating this to death as I just pulled the 170 /6 out of my 66, and am putting in a 318. Again TTI makes one of the best headers for this vehicle, but they are around 600-700.
How many years are between 1452 to 1519?
67
What size rims will fit 1967 dodge dart gt?
14" rims came on the 67 GT dart.
Does a 1967 dodge dart 270 have points?
yes, all 67's had points from the factory.
Will a 1967 and 1968 dodge dart gt grill interchange?
I think the 67 grille was a little different.
Is 67-69 Barracuda fastback rear glass the same?
Yes
Can you put a 1970 front grill and bumpers on 1969 dodge dart?
there is one on you tube look for it its a orange one try 67 68 69 they fit perfect
How many 1967 dodge dart gt convertibles were maunufactured with the 273 V8?
I believe 65 or 66 was the last year of the 273, the 67 had a 318 if I remember right.
What fuses should you use in your 67 Dodge Dart GT?
every circuit has a different rated amp fuse, it should say on the fuse box what amp to use for each circuit.
Will front fenders from a 67 dart fit a 69 dart or vis versa?
Yes, they fit, but you will have to use the respective year grilles as the head light positions are different, with the 69 headlights higher and further towards the grille center than the 67/68 fenders.
How tall is the 2009 Dodge Journey?
The height of the 2009 Dodge Journey is 5 ft. 7 in. (67 in.).
How tall is the 2010 Dodge Journey?
The height of the 2010 Dodge Journey is 5 ft. 7 in. (67 in.).
Is 67 percent the same as the decimal 6.7?
no 67% as a decimal is .67
How do you change 67 percent into a fraction in simplest form?
67% is the same as 67 out of 100. 67/100. ANSWER IS .67.
