answersLogoWhite

0

The car won't start because of the security system. The security system will either have to be bypassed (there are kits available on Ebay sometimes and there are some websites that have them too) or replaced. The ignition key has a built in resistor that the security system checks when you try to start the car. If the security system doesn't recognize the resistance of the key it won't start the car. Then you have to wait 2 to 10 minutes before it will start ( sometimes it's a lot longer than 10 minutes). You could try getting a replacement key and see if the security system recognizes it better. GM installed security systems in their vehicles that are called Passkey I, II and III. So if you get a kit you have to know which system is in your vehicle.

User Avatar

Wiki User

8y ago

What else can I help you with?

Related Questions

Why did your 1999 Chevy Tahoe quit and none of the lights work and it will not start?

Check battery earth connection.


The parking lights and dash lights are out on your '99 Mercury Sable where can you get a wiring diagram for this?

Start with the headlamp switch.


Headlight issue 1996 metro Headlight switch off day time running lights work. Parking light switch on headlights and parking lights work headlight switch on no lights work. Anyone have ideas?

I would start with replacing the head light switch


I have a 1998 Tahoe It will crank but won't start what's the problem?

I had the same problem with my 98 Tahoe. It ended up being the security sensor. The system was recording a security breach and would not start the vehicle. The dealer told me it was reading the chip in the key wrong. You can try and see if this is also your problem. Barrie form Van. B.C.


How to wire a 4-way switch with multiple lights?

To wire a 4-way switch with multiple lights, you will need to connect the switches and lights in a specific way. Start by connecting the power source to the first switch, then connect the first switch to the second switch using 3-way switch wiring. Next, connect the second switch to the third switch using 4-way switch wiring. Finally, connect the third switch to the lights. Make sure to follow the wiring diagram for a 4-way switch setup to ensure proper functionality.


How can I wire a 3-way switch with a 3 lights diagram to control the lighting in a room effectively?

To wire a 3-way switch with a 3 lights diagram effectively, you will need to connect the switches and lights in a specific way. Start by identifying the power source and connecting it to the first switch. Then, connect the first switch to the second switch using a 3-wire cable. Finally, connect the second switch to the lights using another 3-wire cable. This setup allows you to control the lights from two different switches in the room.


How do you start a Chevy Tahoe without a key?

how to start a 1993 chevy tahoe without a key


How do you turn off security system on 1999 chev suburban?

turn the ignition switch on (all the lights in dash light up) but do not crank engine. leave on for half hour untill security light goes off. turn off ignition, wait 30 seconds then start engine.


2001 Monte Carlo Occasionally won't start Then will start Now security light is coming on along with check engine light Any ideas?

More than likely it has a bad magnet in the ignition switch you need to replace the switch and then relearn the security system


Why wont my 1997 Tahoe shift into gear when I press down the brake pedal It has automatic transmission.could it be my netural safety switch?

Stuck in Park? Check to see if the brake lights are working - shift interlock and brake lights are the same circuit. Try turning key to 1st (unlock) position without starting vehicle - shift to neutral to start vehicle and then shift to Drive


How do you turn off the daytime running lights on a 2005 avalanche?

You turn the headlight switch to the left when you start the vehicle.


Why won't my 2001 dodge ram 1500 fwd start?

all of the other lights come on but when I turn switch all away to start wont do it