stonemkr here and I would start by removing the inside door panel and get a visual. You could go online and get the specks for that model and electric scamatics ! Or yell at it and get it over with. Good Luck and patience is required here. Remove inside door panel and work lock while looking at mechanics of lock. Remember think safe!!
when i get out of my car and lock it the lights flash 3 times but there is no red light flashing ca anyone help
It is called " Northern Lights" artist is H.F. Mangold
the ac control head needs recalibrated. to do this, start the engine, set fan to max, control to panel vents, temp to cold, the press and hold the top left and bottom left buttons at the same time until all light s come on. then release buttons and they will start to cycle around. the air will also change from hot to cold, up to down. Should last about 2 minutes. when done only one light should be flashing. press that button and you are done. If more than just the top left button is flashing at the end then there is a problem with the ac system
from what i know there are separate fuses for the left side lights and the right side lights so it might be a fuse
LED lights and CFL lights are a couple
Hold down the lock and unlock buttons, on the key fob, together for several seconds and the system will change to lights with horn.
go to www.lextech.org they have everything you need to replace
To resynchronize the remote press and hold both the lock and unlock buttons for about 8-10 seconds. If you do it right, the horn will chirp and the lights will flash once. You have to be in range of the car.
yes
To answer this question, the purpose of what the push buttons and lights will be required to do in the circuit, has to be stated.
The brake lights.
Probably a faulty brake light switch or the brake light switch is installed incorrectly.
Same problem recently with my 1998 Audi Avant wagon . Anyone with suggestions on how to disable or correct lit radio buttons ??
Two plastic pads on the brake pedal which press on two switches on a bracket are missing. Meaning the switches never get pressed and the brake lights stay on and run down the battery. See a dealer to put new plastic "buttons" in the pedal.
The rear brake lights.
wrong bulbs or bad earth
You cannot turn on and off lights for Samsung tab 3 7.0 because it does not have the soft lights buttons.