answersLogoWhite

0


Best Answer

The cooler lines attach from radiator (on the plastic ends on sides of radiator) facing engine, to the tranny.

You may need to use a flared end wrench to loosen them.

Install new lines and do not overtighten, you may use an open end wrench to tighten.

Properly disopse of old tranny fluid and fill tranny to proper level.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: On 94 Dodge Intrepid is there a diagram that shows how to install cooler lines from transmission to radiator?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

How do you change the radiator on a 2004 Pontiac Grand Am?

I don't own a Pontiac Grand Am but perhaps through these steps that I will list down, you can get some idea about the process. Good luck!Here it is: The radiator cools and stores the engine coolant. It is usually mounted on the front of the engine compartment. These are the things that you should have: New Radiator Combination Wrench Set Screwdriver Flashlight Cooling System Pressure Tester Needle Nose Pliers Socket and Ratchet Set 3/8 in. Drive Ratchet 1. With the engine off and cold, open the hood and locate the vehicle's radiator. 2. Disconnect the negative battery cable from the battery. 3. Remove the radiator cap. 4. Place a drain pan under the radiator. Remove the drain plug or remove the lower radiator hose to drain the cooling system. 5. Remove the upper radiator hose. 6. Remove the radiator fan shroud or remove the electric cooling fan assembly. 7. Remove the radiator. 8. Install the new or repaired radiator. Make sure it is aligned. 9. Install the lower radiator hose and clamp. 10. Install the radiator fan shroud or electric cooling fan assembly. 11. Install the upper radiator hose and clamp. 12. Fill the radiator and radiator reservoir with a 50/50 mix of coolant and distilled water. 13. Install the radiator pressure tester and check for additional leaks. 14. Reinstall the radiator cap and negative battery cable. Start the engine. 15. Monitor the engine temperature. 16. Road test the vehicle, maintaining supervision over the temperature gauge. 17. Verify repair by inspecting for leaks or overheating.


Do radiator sealants work and are they safe?

no.they eat up your hoses so the best thing for that is to take it to the radiator shop it should't cost no more than 100.00 to have fixed and install back on the vehicle


How do you replace the rear main seal in a 1996 Plymouth Breeze?

a lot of work. the transmission has to be removed.


How would you install transmission seals on a '97 Plymouth Grand Voyager van?

You have to remove the trans.


How do you change water pump on 1994 trooper?

Remove the serpentine belt. Drain the water from the radiator. Remove the radiator hose from the water pump. Remove the water pump retaining bolts. Reverse the process to install the new water pump.

Related questions

How do you fix cooling lines to transmission on 96 Chrysler intrepid?

The best fix is to replace them they are available and not that difficult to install.


How do you install a serpentine belt in a 98 Dodge Dakota?

There should be a diagram on the underside of the hood or on the radiator.


How do you install the radiator on a 1997 Honda Passport?

It depends on what type of engine and transmission the Passport has.


How do you change manual transmission into automatic?

This is a major mechanical project. Remove the clutch and manual transmission and the radiator. Install automatic transmission, new driveshaft, new radiator. You have just spent as much as a car is worth.


How do you install 22inch wheels on a intrepid?

you don't, its an intrepid not an escalade


How do you change the transmission on a 2001 Mercury Cougar?

Remove radiator cap. Push Cougar out of the way. Push a better car under the radiator cap. Install radiator cap.


How do you install radiator 1971 Pontiac lemans?

Drain the radiator of fluid, take the shroud off if it has one, take top and lower radiator hoses off the radiator, if automatic transmission you need to take the 2 lines that go into the bottom of the radiator off, unbolt the 4 bolts that hold the radiator in to the radiator support and pull the radiator out, to install new radiator just reverse the process.


What is the diagram for a serpentine belt for a 2000 Chevrolet Cavalier?

The drivebelt routing decal on the radiator shroud to help during drivebelt install


Diagram to install serpentine belt 2000 dodge Dakota?

Open hood, look on the frame in front of the radiator or on the hood itself. Should be a diagram w/ air conditioning and w/out.


How can I (DY) repair my 1995 Nissan Intrepid that only drives in reverse?

With limited knowledge and tools for rebuilding an automatic transmission, and you want to DIY, purchase a good used transmission from a salvage yard and install it yourself.


How can I (DY) repair my 1995 Dodge Intrepid that only drives in reverse?

With limited knowledge and tools for rebuilding an automatic transmission, and you want to DIY, purchase a good used transmission from a salvage yard and install it yourself.


How do you install radiator Isuzu npr?

how do i install a radiator on a 1993 isuzu npr?