Sounds like something with alarm discharged battery.
also your little display that shows messages and what not, that will say Clean Key - wait 3 min if the your passkey wasn't reading right Perhaps you see a Security Light flashing. Turn ignition on and leave on until security light stops flashing (up to 10 minutes) Do this a second time and again wait up to 10 minutes for security light to cease flashing finally a third time - after the 3rd time that the security light stops flashing ... Turn off iginition and try to start. Jon
take a screwdriver and touch the screws of the starter solenoid together
speed control sensor is bad
need new starter or solenoid or starter relay. check the small wire on the lock clyinder and key is probely broken set of the securty system.
i replaced the fuel pump and now my theft system wont work
security light keep flashing put new starter on still will not crank
the flashing security light in the dash is not flashing and vehicle will not start
try putting petrol in
Yes to bypass,Press on the brake, turn car to as then on let the carburetor fill then, put the car in neutral,then start. If the security light is flashing, the car will not start for 10 minutes. Do not try to start while light is flashing.
is your security light flashing? turn the key on, leave on for 10 mins, turn key off let it sit for 2 mins, start car
If your security light is flashing, then you have had what is referred to as a "bad timing cycle" with your Passlok security system. Turn the key to the ON position, and wait until the security light stops flashing - This takes exactly 10 minutes.If the security light WAS flashing, then the 10-minute trick is only a temporary fix - You will need to have your ignition switch replaced.
The factory alarm causing the issue would be the security light flashing above the RPM guage. If the security light is flashing and the car will not start, follow the directions listed below. To reset the factory alarm, turn the ignition switch to the "on" position NOT the start position for 15min. You will see the security light go off after 15min.
The red light indicates a failure in the security system. It will not start with a failure.
Attempt to start the truck by turning the key on the security light should start flashing. Allow the light to flash for 10 minutes light should eventually go off on its own after 10 minutes. Then Cycle the keyswitch again the security light will start flashing again allow this to happen for 10 minutes and cycle the keyswitch one more time after 3 complete cycles you should be ready to turn the truck on and that will be all set.
Once you get the key with the correct chip in it for your car, just turn the ignition on and leave it on until the security light quits flashing, it will take several minutes, then turn the key off and start car
It is possible that the dome light needs to be replaced on the Dodge Neon if the odometer is flashing the word fuse. If the car is also not starting this could be caused by a bad starter or bad battery.
Put the key in the ignition and turn it into the run position, but don't start the car. Leave the key in the ignition until the security light stops flashing. The car will start now.