0
What else can I help you with?
Your battery light comes on and your car stalls out when it idles you drive a 2003 caviler why does this happen?
replace the alternator
Why does my 2003 fords escape xlt slight shimmy going down the road the speed does not matter I have replaced tires brakes drums and disc no noise when i turn?
Possibly a bent or out of balance drive shaft.
How much cost to replace starter on a 2003 Hyundai tiburon?
The cost to replace a 2003 Hyundai Tiburon ranges from $70 to $110. This is dependent on the store and part brand.
2003 dodge ram 2500 series diesel Will not go in over drive what is the most common problem?
to keep it simple do a tranny pan drob and replace tranny filter, this may or may not correct the problem
Can i replace my 2003 Toyota Echo antenna?
You can replace your 2003 Toyota Echo antenna. Remove the antenna retaining nut. Remove the cable from the bottom of the antenna. Reverse the process to install the new antenna.
Can you replace a universal joint in a 2003 Honda CR-V or do you have to replace the whole drive shaft?
You have to replace the whole drive shaft.
How do you replace a 2003 Mazda tribute drive shaft?
To replace the drive shaft on a 2003 Mazda Tribute, first, safely lift the vehicle and secure it on jack stands. Remove the wheels and the bolts securing the drive shaft at both ends (the differential and the transmission). Once the bolts are removed, you can pull the drive shaft out of the vehicle; install the new drive shaft by reversing the process, ensuring all bolts are torqued to the manufacturer's specifications. Finally, reattach the wheels and lower the vehicle.
How do you fix 2003 expedition rear differential pinion seal leak?
remove rear drive shaft. remove pinion yolk from front of diff.remove oinion seal replace with new one. replace pinion yolk, replace driveshaft,.. dhceck ujoints of drive shaft while out, its a good time to replace them
What actors and actresses appeared in Drive Shaft - 2003?
The cast of Drive Shaft - 2003 includes: Christian Lee as Christian Shaun Lund as himself Steve Santagati as Host
How do you replace a drive belt in a 2003 Toyota Corolla?
how to replace drive belt 2003 Toyota matrix
Replace crank shaft sensor on a 2003 liberty jeep?
it sould be on the left side of the motor if your looking at the car on the side of the block under the manifold drive safe
How do you tow a 2003 4x4 Chevy pickup?
remove the drive shaft
Where is the output shaft speed sensor on a 2003 ford explorer xlt with a 4.6L v8?
on the output shaft of the transmission, close to where the drive shaft enters
Should front drive shaft turn while not in 4 wheel drive in a 2003 ford ranger?
In a 2003 Ford Ranger, the front drive shaft should not turn while in 2WD mode. The transfer case disengages the front drive shaft from the drivetrain when the vehicle is in 2WD, allowing power to be sent only to the rear wheels. If the front drive shaft is turning in 2WD, it may indicate a malfunction in the transfer case or related components.
How do you remove the rear drive shaft on a 2003 Honda 350 rancher 4x4?
To remove the rear drive shaft on a 2003 Honda 350 Rancher 4x4, first ensure the ATV is on a stable surface and the rear wheels are raised. Remove the bolts connecting the rear differential to the drive shaft, typically using a socket wrench. Next, detach the drive shaft from the transmission by loosening the bolts or retaining clips. Finally, carefully slide the drive shaft out of the differential and transmission, ensuring to check for any dust or debris in the process.
Where is the propeller shaft no a Nissan Sentra 2003?
I dont believe a 2003 Sentra has a propeller shaft because it is a front wheel drive vehicle. Only rear wheel drive vehicles truly have a propeller or DRIVE shaft. It runs down the center of the vehicle, length ways, connecting the output end of the transmission to the input end of the differential.
How do you remove drive shaft from 2003 Honda rincon ATV?
To remove the drive shaft from a 2003 Honda Rincon ATV, first ensure the ATV is on a stable surface and disconnect the battery. Then, remove the rear wheels and the rear differential cover to access the drive shaft. Disconnect the U-joint bolts from both the front and rear, and carefully slide the drive shaft out of its housing. Finally, inspect the components for wear before reinstalling or replacing as necessary.
