answersLogoWhite

0

There should be end play, aprox .004, depending on the application.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the Longitudinal crankshaft movement controlled by?

what assists in controlling lateral movement of the crankshaft


What is the purpose of the crank shaft?

The crankshaft is an internal component of the engine that converts an up and down movement of the pistons to a rotational movement of the the crankshaft. This is provided to the powertrain for movement. The bottom of the pistons are attached to the crankshaft with main bearings.


What is the job of a crankshaft?

It turns the stroke movement of the piston(s) into a rotation.


Where is the crankshaft position sensor on a 2002 ford ranger?

should be right around the crankshaft. Look for a plug into something around the crankshaft.


What is the relation between the movement of the piston and the movement of the crankshaft?

In essence, the the displacement of the piston is porportional to the sine of the phase of the crankshaft. this isn't quite true but it gives a rough idea of what is happening. if you meant what happens in one cycle of a piston/crankshaft then it is essentially this: as the piston moves down it forces the crankshaft through one half of a revolution and then on the way back up the piston forces the crankshaft through the remaining half of a revolution - back to its start position to start again


What does a crankshaft do?

The crankshaft is the part that connects the flywheel and the piston rods on an internal combustible engine. Its job is to change the movement of the pistons to a circular motion, which is what is needed to power a vehicle.


Would a car stall during normal movement from a bad crankshaft position sensor?

If normal movement meaning driving the car then YES


Where is Knoking sensor in Maxima?

It should be on or near the crankshaft, no?


What assist in controlling lateral movement of the crankshaft?

since you do not name any here is one the thrust bearing


What is the purpose of a connecting rods?

The purpose of a connection rod is to provide fluid movement between pistons and a crankshaft.


How remove crankshaft pulley on Corvette?

it should be on the instructions or when you get the car they should tell you


Gmc 2002 Yukon crankshaft position sensor location?

I have been having problems with finding the crankshaft sensor, what should i do or what can i do?