No the e-coat is a electro-static primer. It is very durable just make sure it is scuffed properly before priming or painting.
Because when pain't is wet, you will just be spreading it around with your paint brush. It will look uneven and bad. When the paint is dried, it is a solid surface to paint.
It should tell you on the can as every paint is different.
extra fine sand paper should do fine
If your gloss white is good quality, then a single coat should cover a grey primer.
Usually there is a base coat of a solid colour, a coat of the chameleon paint, and then a clear coat
Yes, it is recommended to sand after priming before applying the final coat of paint to ensure a smooth and even finish. Sanding helps to remove any imperfections and rough areas, allowing the final coat of paint to adhere better and result in a professional-looking outcome.
The primer on a wall should look smooth, even, and fully dry before applying the final coat of paint.
Because when pain't is wet, you will just be spreading it around with your paint brush. It will look uneven and bad. When the paint is dried, it is a solid surface to paint.
It should tell you on the can as every paint is different.
if you are trying to remove paint from the outer body of the car and you are looking to paint it. then start by sanding the outer body down to the bare metal then use your primary then first coat then second coat of paint
Yes, you can prime over existing paint before applying a new coat of paint. This helps improve adhesion and coverage for the new paint.
It is generally recommended to let paint dry for at least 2-4 hours before applying a second coat. However, it is important to follow the specific instructions on the paint can for the best results.
extra fine sand paper should do fine
Yes, you can sand primer before applying the final coat of paint to ensure a smooth and even surface for better paint adhesion.
Mixing clearcoat with paint, will ruin the paint.For enamel paints, make sure you use an enamel clearcoat. You should allow the paint to fully cure (at least a week) before attempting to apply the clearcoat. Never use a lacquer based clearcoat on an enamel based paint. It will ruin it.For lacquer based paint, you should only use a lacquer based clearcoat. The paint should be dry, but does not have to be fully cured, since the lacquer will wet the coat of paint below it anyway.
a coat of paint
If your gloss white is good quality, then a single coat should cover a grey primer.