If the light for the gear shift on the console does not work on a 2002 Toyota Camry, it is probably a burned out bulb. The console will need to come off to access the bulb to change it. This part is held onto the console area by screws.
Just remove the console and you can get to it.
There is one illumination bulb to light up the gear shift indicator. Remove the center rear console, then the console around the shift lever, and you will see the wires on the left side that go to the bulb. Twist the small socket and it will come out, then just put in a new bulb.
its beside the shifter under the console. if your car is stuck in park, take off the console, and pull the shift solenoid out or engage it and then zip tie it to a bracket that doesn't move. and it will work from now on.
Inside the floor shift console. Should have an access panel on the right side of console that can be removed to gain access to ECM.
Stands for Electronic Controlled Transmission. The button switches the transmission between Normal & Power Mode. The Power Mode changes the shift pattern to allow the transmission to up-shift at a higher RPM. For instance the Normal Mode up-shift will occur at 37 mph and the Power Mode up-shift will occur at 47 mph. Fuel economy will suffer in the Power Mode. Normally you would leave it in the Normal Mode unless you want a little more sporty feel.
How can you change the light bulb for the gear shift on a 2002 Toyota Camry?
Can I get an answer to the above question
I believe that there is a button that controls this light. I drive a 95 Toyota Camry Coupe, and on my console down by the Gear Shift there is a small button labeled "PWD". When engaged (Down) the light is off, and when disengaged (up) the lGren PWD light shows on the Instrument panel. My understanding is it has to do with Traction Control Hope that helps!
Owner's manual.
The Camry in 1990 doesnt have a shift solenoid. It was controled by a hydraulic shift governor inside the transmission. So the trans. has to come out and be opened up.
the shift pattern select switch in the center console turns the light on or off. it should also sat "power" on it.
Begin by removing the 2002 Jeep Liberty shift console retaining bolts. Lift the shift console up and the light bulb will be visible. Take hold of the light bulb, push in and turn at the same time to remove it. Reverse the process to install your new shift console light bulb.
There is a little button on the transmission shift stick, from the driver's side. Just press it, and you will see light in your dash board... And you will get what you want.
Any body know the answer to this....I got the cover off of the console but don't see where the light bulb is.....I see wires running up underneath but not a good way to get at them to see if light bulb is attached.
shift solenoid e malfunction in a 1998 dode
no it will not. the 1995 Camry has one speed sensor, the 1992 Camry has two speed sensors. The car will go into limp mode and after 10 minutes of driving the Overdrive light will continue to flash indicating a shifting problem. It will not shift in 1st or 2nd gear. It will stay stuck in 3rd gear (limp mode)
Check transmission fluid level.