0
The process of cutting decorative zigzags along the edges of fruit halves in named in honor of the pointed beards found in whose paintings?
Rhicksg
Van Dyck (vandyking)
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What process did Renoir use to create his artworks eg make miniatures or sketches or take photographs?
He was not a keen photographer, but there are sketches left for some of his paintings.
Does cutting down trees increase the amount of carbon dioxide in the air?
Cutting down trees does increase the amount of carbon dioxide in the air because trees take the carbon monoxide in the air and turn it into oxygen in a process called photosynthesis. Without as many trees then there is going to be more carbon dioxide in the air.
How do you cut the patiala salwar?
AnswerAnswer 2See the links shown below. salwar pants or patiala pantsgo to Youtube at; adithisammasews dot com for a Patiala pants pattern.
What is a wet edge?
A wet edge is a decorative arts term (faux finishing). It applies to the glazing process. The artist, while applying the glaze, works in sections on a wall. They must make sure that the glaze does not dry on the outer edge in order for it to be joined to the next section. If it does dry, the result is a "dry edge" that creates a line and ruins the entire look of the faux finish.
What style did Jackson pollock use in Blue Poles?
Jackson Pollock's Blue Poles is one of his drip paintings it is essentially not to be representational like looking at a portrait of a man but represent the action of painting, his action painting communicates the process of painting itself, open up to subconscious understanding.
What is process of cutting diamond called?
The process is called diamond cutting.
What is the process of cutting a hedge is called?
The process of cutting a hedge is called Topiary
What is the difference between cutting tap and roll tap?
tapping is a metal cutting process & rolling is a forming process.
What are plasma cutting and its processes?
Plasma Cutting is process by which all types of conducting materials can be cut. This is an economic commonly used process for steel cutting in the industry today.
Does cutting a strip of aluminum describe a chemical change?
Cutting is a physical process.
Why do environmentalists prefer the process of selective cutting to clear-cutting?
cuz I said it should be
Is naping a decorative finished?
No, "naping" is not a decorative finish. It refers to the process of aligning the fibers on fabric to create a certain texture or appearance, such as in the case of velvet or corduroy fabrics.
Is the steel rule die cutting process relatively simple?
The steel rule die cutting process is a very complex process to undertake. People who are involved with this have years of specialized training.
What is the process for plasma cutting?
The process for plasma cutting is fist of course have all the requerd saftey gear.Then make sure the material you are cutting is properly secured to the press.Then to start the cutting turn on the plasma cutter and carefuly aply flame to material.
What is the name of the slender pointed projection on the distal end of the ulna?
The same as the slender, pointed projection on the distal end of the radius: the styloid process
The cutting process results in oxides that mix with molten iron and produce?
Oxy-fuel welding and cutting process results in oxides that mix with the molten iron.
Is Laser cutting of steel a thermal cutting process?
CO2 laser cutting carbon steel with oxygen is an exothermic (thermal) process. The oxygen used with the laser cutting burns the steel, thus assisting the cutting process. This process causes striations, or lines, to form at the cutting edge and provides lower cut quality but faster cutting. In contrast, when cutting stainless steel with nitrogen, only the heat from a CO2 laser performs the melting (operating in the far infrared region at 10600 nanometers). The nitrogen assist gas pushes the melted material down and out of the way, leaving the cut that is typically a polished edge.
