What causes it not to crank? First thing to look at is the battery. Have it tested to see if it is working as it should. Most times, if its not cranking at all, its the battery.
do you have gas in the tank
Check your ingnition cylinder ...
The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.
This could be a problem with your cam sensor, or crank sensor.
In most cases the crank pulley bolts to the balancer so the crank pulley would not be the same as the harmonic balancer.
What I do on my 1995 Ford Explorer XLT is go around to the passenger side and tip the rear seat back forward as if I wanted a larger cargo area . There is a panel on the floor that is directly behind the rear seat back . Lift that and the ( 2 ) rod sections are held in place by clips . The jack and lug wrench ( which is used as the crank handle for the jack ) are located behind the removable plastic panel in the cargo area , on the drivers side , by the liftgate
bad crank sensor
my 2003 Ford Expedition seem to have a fuel or relay malfunction. I can get the truck to crank if the doors are locked and unlocked several times, but it still will not start at all.
Where is the crank sinsor on a 98 ford explorer sport
problably your crank positioning sensor, on the front of motor, behind crank pulley. about a $40.00 dollar part. good luck
Common causes of bike crank wobble include loose crank bolts, worn out bottom bracket bearings, or a bent crank arm. To fix it, tighten the crank bolts, replace the bottom bracket bearings, or straighten or replace the crank arm.
Hi, The idle air control (IAC). Mounted close to the throttle body.
underneath the rear of the truck - lets down with a crank
do you have gas in the tank
the crankshaft sensor is located behind the crank pulley. the bottom pulley
mass air flow sensor
fuel pump or crank sensor