Some polyurethane can be the dickens to get to soften up. After polyurethane cures it's actually a sheet of plastic. I recommend Citristrip Stripper it's real user friendly and safe to use inside. As with all chemicals, be sure you have good ventilation though. Citristrip has a long open time and if conditions are right it'll work for up to 24 hours. I would suggest applying a coat of stripper and letting it sit for a few hours, then apply another coat of stripper over the first one and cover the area with a plastic drop cloth. Let it sit overnight and try scraping. If the stripper has dried apply another coat and wait an hour and try it. Usually that will do the trick.
Bleach
Often, poly will not adhere due to contaminants on the surface. Remove all of the loose coating, sand the surface, brush off the surface with a brush, then remove the remainder the dust with a tack cloth.
The secret to getting a juice out of hardwood floors is to try to get to the stain before it sets into the wood. A water and vinegar mixture can be used to remove a juice stain from hardwood floors.
You don't. You will most likely have to restain after stripping.
You can remove stains or blemishes from a polyurethane watch by scrubbing it with a wet terrycloth that has been dipped in a solution of warm water and liquid dish soap. For tough stains, dip a melamine foam sponge into the solution, ring out and wipe the watch gently. Dry well with a clean towel.
form_title= Prefinished Hardwood Flooring form_header= Install hardwood flooring in your home. What is the square footage of the room(s)?*= _ [50] Do you need to remove old flooring?*= () Yes () No What type of wood would you like?*= _ [50]
use your nails, scrape it off gently with a flat head screw driver...?
how to remove polyurethane from a brass bed
To remove the residue, use either Goof-off or Bostik's adhesive remover. Both are safe for use with Polyurethane finishes.
Bleach
flooring
I recommend Nature's Miracle. It works on my hardwood floors, rugs and carpet great! It will be more effective if you let it sit for a while, though.
Remove all dirt, oil, rust, sand lightly, I would recommend a primer first and then apply a at least 2 coats and you will be fine.
the best ways to remove scratches from a hardwood floors are either you sand it or have someone do it for you
Best way to clean hardwood floors is with a damp mop. Before mopping, make sure that you have removed all surface dust from the floor. To remove wax you should consider buffing out old wax and resurfacing the floor. Heat and scrape. I would recommend being careful. Damaging your hardwood floor could cost a lot of money to repair in the long run
sandpaper
You can remove polyurethane from fabric by scraping off the excess using a rubber scraper. Use the blade of a sharp knife to further remove the top layer of polyurethane. Then, apply acetone to the stain and allow it to work for 10 minutes before rinsing the fabric with water. If the fabric is white, soak it in bleach and water for 30 minutes, then wash as usual.