if only one is broken,and others are tight, you can safely drive to get it repaired.it is not a big or expensive rpair
To check for a leak, apply soapy water to the stem and look for bubbles.
It's broken!
Not knowing which mirror on what vehicle, many glass shops can replace the mirror if that is all that is broken.
Wikipedia: On September 17, 1925, Kahlo was riding in a bus when the vehicle collided with a trolley car. She suffered serious injuries in the accident, including a broken spinal column, a broken collarbone, broken ribs, a broken pelvis, eleven fractures in her right leg, a crushed and dislocated right foot, and a dislocated shoulder. An iron handrail pierced her abdomen and her uterus, which seriously damaged her reproductive ability.
they will repo it
it is broken and somebody needs to fix it fast and it is also cut in half
pain and a few broken bones
Nothing, you have extra money and a broken vehicle.
leaf or coil.. car will lean to one side.. eventually causin any number of probs
Nothing much serious. But broken axle will damage your car this may include broken engine , ball joint etc. Best thing is to change it every 50000 km.
A broken coil spring will cause the effected corner of the vehicle to drop. A broken ignition coil will cause the engine to misfire (coil on plug application) or cease to run.
Yes. I did that, works well.
Car wont run & on interference engines there will be serious internal engine damage.
That is called A antitheft nut. You should have A tool in the car for it, It will likely be in the trunk near the spare tire or in the glove compartment, It will look similar in size to a lugnut and it will fit A tire tool on one end and be the reverse ov the lugnut on the other. ,,,,,,,,,,,,,,,,,,,,,,,,,,,,, If your tool is lost, Go to A dealership, They will remove them for about $20 each.
You may be referring to the valve stem on each wheel.
can a car be sold with a broken odometer?
to replace a wheel stud, depend on the type of car or truck, jack it up and block it. remove the affected wheel and use a hammer and a punch to drive out the broken stud. most automobiles have an access hole to replace studs with out removing any more components. however some do not. to install place stud in hole and use some washers and a lugnut to mount in place.