0
If the motor was NOT started, if the head bolts WERE NOT torqued, then you would just need to make sure the head gasket was not pressed and put the head on correctly (head gaskets are cheap replace it if there is even a question).
If the head bolts were torqued (tightened at all) you must replace the head gasket.
If the motor was started then it depends on how hot it got. Water passages normally do not line up so the engine overheats very quickly because there is no coolant flow, oil flow is also interrupted in most cases; this leads to a myriad of problems including cracked heads, scorched bearings, etc. In this situation it is best to remove both heads, check the block deck to ensure it is not warped, and have the heads tested (re-tested) to ensure they are not warped or cracked.
What else can I help you with?
What happens to the motor when you put in a thermostat backwards?
It will probably overheat. answer= thermostat will not open and will prevent the flow of coolant . which will in turn do damage to your engine
What happens if you put a heart in the wrong way?
It does not beat
How do you remove an ignition tumbler cylinder from a vehicle?
on an older car you put the key on accessery, push a needle in the little hole in the cylinder then turn the key to the left and pull on the key
What happens if you put face paint on your eyelid?
Gees you get paint on your eyes
What happens when you put tear drops in someones drink?
nothing. but if you put EYE drops in someones drink they will have an intestinal situation.
What happens If you put ps3 game backwards?
It will tell you it can not read the discc
How do you repair a head gasket 1994 Chevy G20 van?
You will need to remove the cylinder head from your 1994 Chevy. Remove the head gasket and clean the surface. Put the new head gasket on and put the cylinder head back to its original position.
Replace head gasket in s10 4-cylinder pickup?
Begin by removing the cylinder head from your Chevrolet S 10 four-cylinder engine. Remove the head gasket and clean the surface. Put the new head gasket on and return the cylinder head to its original position.
What happens when you put a clutch in backwards?
You cannot physically put a clutch disk in backwards unless you force it together. If you do this you will destroy the clutch disc and possibly other clutch components.
What happens if you put a PCV valve in backwards?
pcv valve wont work properly
What happens when a fly wheel is put on backwards?
It rotates the other way. Yeah, right. You CANNOT put a flywheel on backwards. It's not physically possible to mate the flywheel with the crankshaft unless it is the correct direction.
How do you change head gasket on Chevy Lumina?
You will need to remove the cylinder head from your Chevy Lumina engine. Remove the head gasket and clean the surface. Put the new head gasket on and return the cylinder had to its original position.
Can you put an h22 cylinder head on an f22b2 cylinder block?
Try posting this question on hondaaccordforum.com. You'll probably get a good answer there.
What happens when you put a battery in backwards in a pt cruiser?
You could have blown fuses, melted wiring or damaged computers.
How do you put a cylinder head on a Yamaha blaster?
To install a cylinder head on a Yamaha Blaster, first ensure the surface of the cylinder and the head are clean and free of debris. Position the head gasket on the cylinder, aligning it properly, then place the cylinder head on top. Secure the head using the appropriate bolts, tightening them in a crisscross pattern to the manufacturer’s specified torque settings. Finally, reattach any necessary components, such as the exhaust and intake, and check for proper alignment.
What happens if you put a egg in your head?
Your leg becomes a chicken
What happens when you put your car battery in backwards?
When you connect the battery backwards you can cause major damage. You can blow the alternator or its fusible link. You can destroy electronics, particularly the various computers - and these are not cheap.
