I'M NOT A MECHANIC but if I'm reading this right it is a heated oxygen sensor , (bank 2 , sensor 1 ?) Which would be the heated oxygen sensor on the driver's side of the engine , either screwed into the exhaust manifold or into the exhaust pipe near the engine. (Helpfull)
That would be a ( 12 volt battery ) in the engine compartment of a 1998 Ford Explorer
Tell me if just one window or all of them quit working
well,, you can start by turning the switch on your dash that says '4wd'
The 1998 Ford Crown Victoria windshield wiper relay switch can be found on the firewall in the engine compartment. The windshield wiper relay switch will be on the passenger side of the firewall.
The daylight running lights of a Ford Explorer can be turned off by using the manual headlight control switch. Place the switch in the middle position to turn the daytime running lights off. The headlights will then need to be turned on manually at dusk.
According to the 1998 Ford Explorer Owner Guide : The fuel pump inertia switch ( shut off switch ) is in the front passenger footwell , behind the kick panel
The 1998 Ford Explorer Owner Guide shows that the fuel pump shut off switch is behind the kick panel in the front passenger footwell
Yes , on a 1998 Ford Explorer the fuel pump shut off switch ( inertia switch ) is located in the front passenger footwell behind the kick panel
left side of dash
No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.
If I remember correctly , the fuel pump inertia switch is in the right front passenger footwell , above the carpet , in the corner by the kick panel P.S. the owners manual states it is behind the kick panel on a 1998 Ford Explorer
No
what are the wheel alignment specs for 1998 ford explorer
In the right front passenger footwell , by the kick panel
passenger side floorboard under the heater unit
A 1998 Ford Explorer uses refrigerant 134a
how do you remove a fan blade from a 1998 ford explorer