0
It's a symmetrical sloping flat surface at a 90 degree edge or corner.
Allison Morgan
Add your answer:
Earn +20 pts
How do you measure a chamfer?
A chamfer is a beveled edge that joins two surfaces. The tool used to measure a chamfer would be a caliper.
What is the meaning of chamfering?
of Chamfer
What does a Chamfer do?
A chamfer 'breaks' a sharp edge. eg. after drilling a hole, it is normal practice, especially after drilling in metal to chamfer the edge. eg. chamfers can be made to the edges of prepared wood to prevent the edge breaking away, or causing splinters. Generally the most common form of chamfer is one of 45º
How do you use a chamfer cutter?
how do you use a chamfering cutter
Why to chamfer washers?
If you are asking "What is a chamfer washer?" ?? These are used for bolting together sections of RSJ which have a tapered profile on the inner faces. consequently the bolts pull up "square".
Which bone is a chamfer cut performed on in a total knee replacement?
femur
What is it called to produce a cone-shaped end to a hole?
Countersink of chamfer (I think)
What is a chamfer strip?
A chamfer strip is a small piece of wood or plastic that is used to cover gaps or create a beveled edge on corners of furniture or walls. It is typically installed for both decorative and functional purposes, such as preventing injuries or protecting edges from damage.
What is a disc pad chamfer?
slot cut down the center of the pad. it is there to disapate heat and gases caused by the friction of pad to rotor contact
What is the Machining operation that uses a toothed cutting tool to produce shapes inside of a hole?
counter-bore chamfer counter-sink
What is the definition of 'bevel'?
A bevelled edge refers to an edge of a structure that is not perpendicular to the faces of the piece. Moreover, the words bevel and chamfer overlap in usage.
Why chamfering is done?
A chamfer as a beveled edge of a hole, frequently (but not always) cut at a 45° incline to the 'normal' surface. The chamfer is USUALLY used to allow the head of a screw or bolt to sit below the surface (i.e. a flush fit), rather than sticking out. It is also used when performing a 'deburring' operation; running a small cutting tool around the perimeter of a hole (especially in metalworking) to remove any sharp edges or splinters. In this case, the chamfer is non-functional, it is just a result of the deburring operation. A large chamfer can also be created to provide a 'lead-in' for a screw or bolt; these are usually much larger and deeper, and are cut at a 60° angle, rather than 45°.
