0
What else can I help you with?
Can you fire wire in a clay sculpture?
This depends on he melting temperature of the wire that you are using. It also depends on the firing temperature of the clay. If the melting temperature of the wire is higher than the firing temperature of the clay, then wire can be added to a clay piece.
What makes clay hairy?
Clay get's hairy when you leave it outside for a long time and it get's moldy.But it get's moldy in a special way and turns hairy!!! Clay can also turn hairy if you cut your hairy and glue it on the clay. =hairy clay
What is ball clay?
Ball clay is a variety of clay which commonly consists of 20-80 percent kaolinite, 10-25 percent mica, and 6-65 percent quartz. This clay used to be cut into balls of a mass of around 30 pounds.
Your 92 ford ranger wont start unless you put gas in te intake?
check fuel cut off switch or ground wire by battery small wire on neg side of battery cable or fuel and eec relays under hood
The famous artest who cut off his ear?
Vincent Van Gogh cut off his ear.
How do you cut clay with cheese wire?
You cut carefully so that the wire does not touch the middle of the clay.
How do you take off the governor on a 49cc scooter Is there a wire you can cut?
Cut the blue wire that goes into the actual motor
Can you fire wire in a clay sculpture?
This depends on he melting temperature of the wire that you are using. It also depends on the firing temperature of the clay. If the melting temperature of the wire is higher than the firing temperature of the clay, then wire can be added to a clay piece.
How do you strip wire?
There is a wire stripper you can buy at a hardware store. It looks like pliers, but has a sharp inside edge that when the wire is put into it and held it will cut and strip the plastic off the wire.
How do you bypass rev limit wire on peace sports 50cc moped?
Cut the wire or take it off.
How do you Connect on and off switch between continuous wire?
First you turn off the power. Then you cut the wire. Strip each end of the cut wire and attach to each side of the switch. This should only be done within a switch enclosure. If there is no extra wire to make a good connection, you can extend the cut ends with wire of the same size as the cut wire and use wire nuts to securely connect the "pigtail" wires. You should only switch the hot side (Black wire in home wiring) and not the white wire which would pose a shock hazard.
How can I safely and effectively cut cable wire without causing any damage or injury?
To safely and effectively cut cable wire without causing damage or injury, follow these steps: Turn off the power source to the cable wire. Use insulated tools to cut the wire. Wear protective gear such as gloves and safety goggles. Make sure to cut the wire cleanly and avoid any nearby electrical components. Double-check that the power is off before cutting the wire.
Cut a wire to disable alarm in 95 dodge stealth now will only run for 30 seconds and shut off What is wrong?
You can not just cut a wire to disable an alarm. You will have to hook that wire back up.
No tailights on a 1999 Buick Park Avenue?
check wire's in trunk right side i had one cut off it was a brown wire
How can I learn how to cut speaker wire effectively?
To learn how to cut speaker wire effectively, you can use wire cutters or a sharp knife to make a clean cut. Measure the wire carefully before cutting to ensure the correct length. It's important to strip the insulation off the ends of the wire before connecting it to the speaker or amplifier. Practice cutting and stripping wire to improve your skills.
How do you cut guitar strings with a wire cutter?
If they are on the guitar, loosen them first. If you are cutting the ends off, don't cut them too short.
When was Cut the Wire created?
Cut the Wire was created in 1987.
