answersLogoWhite

0

Mostly used in automatic transmissions, the accumulator piston is located in the accumulator. The accumulator consists of a cylinder and spring loaded piston and is used to provide fluid to the internal shifting servos at a rate higher than the pump can provide. Between shifts, some of the fluid from the pump id diverted to refilling the accumulator for the next shift.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is an accumalator?

An accumalator is a backpack in runescape that saves arrows as you fire them.


Where is the Low pressure air conditioner recharge valve f350 van?

passanger side engine compartment might be on accumalator or line


What are the Difination and terms of car piston and piston parts?

One of the parts in the piston are the piston head,


How do you engage the ac compressor to add freon on a 1990 Buick Riviera?

there is a high pressure switch on the line or the accumalator, unplug it and place a jumper wire into the connector


What are bent engine pistons?

A bent engine piston is a reference to the piston rod. The piston cannot be bent, but the piston rod can be bent.


Why there is rings in piston?

The piston rings create a seal between the piston and the cylinder wall.


What are the Parts of the piston?

There is the penis, the testicles, the scrotum, the prostate, the sperm duct etc.


What is a piston seal?

A piston seal is a gasket designed to keep fluid from leaking around the piston. Piston seals are commonly used in brake calipers.


If the piston on the rear caliper screws in and out and the pad has a nipple that seats in the piston notch how will the piston twist its way out?

The piston doesn't twist it's way out. There is a ratchet screw adjustment that takes up the slack behind the piston. Screwing the piston back in resets the adjustment.


What is a piston ring compressor?

It is a spring metal sleeve that goes over a piston to compress the rings so that the piston can be install in the motor. It tightens down on the piston, forcing the rings into the grooves in the piston then you tap it into the cylinder.


What is the function of a piston rod?

It connects the piston to whatever the design calls for the piston to push or pull on. In a combustion engine, the piston rod connects the piston to the crankshaft, turning linear reciprocating motion into rotary motion.


What is difference between piston rod and connecting rod?

A piston rod connects the piston to the crankshaft in an engine, transmitting the force from the expanding gas to the crankshaft to generate motion. A connecting rod connects the piston to the crankshaft, converting the linear motion of the piston into rotational motion to drive the crankshaft. In summary, the piston rod is part of the piston assembly, while the connecting rod is part of the crankshaft assembly in an engine.