The coolant filler cap can be located in two places....depending the model of vehicle. On late model cars, it's located usually on the left or right side of vehicle in the engine compartment. Usually its a clear plastic tank with hot or cold markings on it. And the top of tank has a cap on it usually with the word coolant on it. On older cars, its located on top of the radiator which is in front of the engine. Normally located on the left side of radiator. It will usually be made out of a hard plastic or metal with the words caution..underpressure...or coolant, etc.
There is no radiator cap, you must fill through the coolant reservoir.
The gas (or fuel) filler-neck (or tube).
Probably a blown head gasket
The cooling system on this vehicle does not use a radiator cap on the radiator but on a remote tank. It may have a different (larger) cap on it than what you are used to seeing on the radiator.
Drain existing coolant from the plug at the bottom or rear of the radiator Flush radiator with clean water until water runs clear Re-fill radiator slowly (to prevent an airlock) with a mixture of 50/50 water and antifreeze Run engine to normal operating temperature with heater on Re-check coolant level
No. It means the cap is not on tight enough. The coolant tank could also have a leak.
Fill the vehicle with coolant and leave the filler cap off. Start the vehicle and keep adding fluid as the coolant level drops. When the motor is warm enough for the thermostat to open up you will see the coolant level drop quickly. Put in more coolant until it is full then shut off the motor and put the filler cap back on.
Normally in the coolant reservoir recovery tank. If you have the supercharged model it is located on the radiator beneath the filler cap and oil cooler lines.
The engine coolant on a 1991 Honda Civic is replaced by turning the drain petcock and releasing the coolant. The filler cap is then removed and coolant added until the system is full again.
The radiator cap and filler are part of the upper radiator hose.
Oil filler cap cover the hole in the engine where engine oil is added
An oil filler cap is a metal that covers the hole where the oil is poured.
Filler cap for 1400 jcb backhoe
Open filler cap, add oil, replace filler cap...
there is no filler cap. pull the tranny dipstick and use a funnel.
I have a 2004 and there isn't a fuel filler cap release.
Check the oil filler cap or the owners manual for recommended viscosity.Check the oil filler cap or the owners manual for recommended viscosity.