The minimum thickness is cast into the rotor, either on the edge of the rotor or into the rotor hub.
The caliper holds 2 brake pads in
In most Fords the rotor will come off when you unbolt the brake caliper.
Nothing, they rub slightly at all times. There are no return springs like a drum brake. Self adjusting.
sounds like you have a stuck brake caliper on the dirvers side. You may have a bad rotor on that side. A warped rotor would cause the disc brakes to wear out quicker. A new rotor is usually cheaper than getting one turned; usually between $20 to $40. Your caliper is sticking pushing the brake pad out. Look to see if brake hose is twisted. Had samething drove me nuts changing things saw the hose took the twist out. Have not had the same problem since, been 8 months.Bill
you have to unbolt the caliper off the rotor, but not from the brake fluid line.
The minimum front brake rotor thickness is three aids of an inch. When the rotor does not have the minimum thickness the auto mechanic replacing the brakes can not use the rotor.
22mm is the minimum rotor thinckness for the front and 12mm for the rear's
The minimum brake rotor thickness for the front and back rotors on a 1992 Honda Accord is 21mm. Rotors which are below this thickness will not offer adequate or reliable braking.
It is important to have all the parts in a car in the best condition. The minimum front brake rotor thickness for this car is 21.4 millimeters or 0.843 inches.
The 2001 Pontiac Grand Am minimum brake rotor thickness is .075. The minimum brake rotor thickness is a standard minimum. Certified mechanics cannot use the brake rotor when the thickness drops below this level.
The brake rotor minimum thickness is .060 This applies to either the 2.3CL or 3.0CL, front or rear rotors. Seems awfully thin for a brake rotor, doesn't it? Other sources say .83 in. (21mm)front, .35 in. (9mm) rear [AcuraFixerDave] That rotor thickness is probably the BRAKE PAD thickness minimum, not including the steel backing plate [AcuraFixerDave].
The minimum thickness or a front brake rotor to be turned is one quarter of an inch. If the brake rotor is less than a quarter of eight inch. It must be discarded.
The minimum thickness number should be cast into the rotor.
What is the minimum rotor thickness of the front and rear brake rotors on an '03 VW Jetta TDI?
The minimum brake rotor thickness for a 1994 Ford Thunderbird car is .974 inches for the front rotors and .657 inches for the rear rotors.
how thick should a front rotor on a 2005 envoy be
The answer and dimensions are stamped in the stock brake rotor of your vehicle.