18mm
It was decided in a meeting by someone putting a coin from
the Netherlands on the table and said that size would do.
With a center punch and hammer.
The hole in the black plastic head sometimes. If it has a transponder the hole is offset to one side and thick plastic. Non transponder usually has a thinner black head with hole in center top of key.
2007, with near record size in 2008. 2009 not yet checked in at the time of this answer (2009apr20).
The Stepdaughter??
yes, most Toyota wheels fit on Chevy 1/2 ton, but they don't have the same seating on the center hole the Toyota is bigger so you have to rotate tires more often. so they don't cup.
The theory is that there is a hole at the center of the universe, but that it is smaller then the size of an atom. Otherwise nothing is really known
The center of the rim is 66.1mm in diameter on a 2005-2008 Nissan Frontier.
It would get larger due to the expansion of the metal (see the related links)
There is no definitive answer to this question as it depends on various factors such as the size and consistency of the P hole, as well as the licking technique used.
it is already on DVD
Its Not On Dvd Yet
the average size of a DVD case is about the size of my penis.. 12 by 12 hahah
It is 6 inches in diameter located in the center of the board and 9 inches from the top of the board to the center of the hole. For cornhole board design ideas check out: http://www.cornholeace.com/cornhole-board-designs.php
The event horizon is the "point of no return" - nothing inside that can escape. In the simplest case (of a non-rotating black hole), this is a sphere, at a certain distance from the black hole's center. The size of the black hole is often taken to be the size of the event horizon.
it already came on DVD
Get a power drill, get a measurement of the size hole you want, purchase a hole saw and head for the measured size. Then take some measuring tape and measure out dead center from all side of the table, use a protractor or whatever you prefer to give you guide lines (if you need them), then drill your hole. Otherwise, find a handyman who will do it for you.
Just about where the center of the hole is.