answersLogoWhite

0

What else can I help you with?

Continue Learning about Art & Architecture

What is a glass tumbler?

Locks have what are called tumblers. Your ignition key turns the lock within the tumbler assembly. The tumblers fall into the groves on the key allowing it to turn. Insert the wrong key and the tumblers are not aligned properly and the key will not turn.A tumbler is a flat-bottomed glass with no handle, foot, or stem.


What hill did Jesus go to after the Last Supper?

He went to the Mount of Olives which is a mountain ridge in East Jerusalem with three peaks running from north to south. It is named for the olive groves that once covered its slopes.


What is a piston in a car?

A piston is located in the Center of the engine, it mixes fuel and ignites it by moving up and down. this up and down movement is caused by the crankshaft which spins really fast with groves were the pistons shafts connect. the piston head is the piece that effects the fuel ignition.


How do you remove a rear drum on a 98 Ford Escort?

Sometimes it is a chore. If it is rusted on, you jay have to use heat around the hub. If the shoes have worn groves in it, you have to retract the shoes with the adjusters. If push comes to shove, you just pry them off destroying the springs and retainers. You have to know how they go back on though.


What is the best way to fill in the grooves in paneling prior to painting?

Sand the area where the groves are. This will clean the area for the next application. Assuming the the panels are made of wood in this instance then purchase a good quality wood filler. This is bettter than wall fillers which are made of a silica powder as the wood filler allows for some expansion in wood. Fill the joints with the filler leaving it slightly proud of the groove. Then using either an electric sander or an 80 grit sand paper wrapped around a wood block sand the joint until its smooth and flush with the surrounding panels surface. Make sure that you leave at least 12 hours between filling and sanding to make sure the filler in its depth is hardened. then prime, lightly sand,wipe all dust off, undercoat, sand with a light 220 grit and wipe againt to remove top dust and then apply the top coat x 2