0
What else can I help you with?
What does a '32 EGR failure' mean on a 1988 Chevy Corsica?
the egr valve may be bad call a parts store they should be able to tell you
What else would you replace on a 1988 Chevy Corsica if the car wont start unless you pour gas directly into the carburetor?
fuel pump is the first place i would look
Is there more than one blinker relay for a 95 Chevy Corsica?
In fact there are none. That's right- there are absolutely no relays for the blinkers. But, there is a flasher, which it sometimes goes bad, and needs to be replaced.
What tools do you need to change the front brake pads on a 2004 Chevy Cavalier?
You will need a one inch socket and ratchet. You also might need a mallet. The socket and ratchet will be needed to remove the lower control arm nuts. The mallet might be needed to loosen the control arm.
You have a 1995 Chevy Corsica that won't start and the Lights come on and battery is fine but you turn the ignition and you get nothing Could this be the starter?
It could be the starter, keyswitch, neutral lockout switch, wiring connector or any of a number of other problems. Unfortunately you have to just track it down.
What size Allen wrench is needed too remove caliper on 93 Chevy Corsica?
You need a 3/8 Allen Wrench
Allen wrench size needed to remove caliper on a s10 Chevy blazer?
3/8"
What size wrench is needed to remove the caliper bolts on the front brakes of 1979 Chevy blazer?
It should be a 3/8" Allen wrench.
What size wrench is needed to take the front caliper off a 1992 Chevy pickup?
I believe that's a 3/8 Allen wrench.
What size wrench is needed for the 2 bolts that hold the caliper on 2004 Chevy Suburban?
Try 3/8 Allen key , or 15 mm wrench.
What size wrench is needed to remove the caliper bolts on the front brakes of a 1995 Chevy Suburban?
the caliper bolts require a 3/8" Allen wrench. You can buy these as a socket at just about any parts store.
What size wrench is needed to remove the caliper bolts on the front brakes of a 2001 Chevy Suburban?
It takes a T55 Torx bit on the front calipers.
What size socket is needed to remove caliper bolts on a 1996 Chevy s-10 4x4?
A 3/8" Allen socket or wrench will work.
What size wrench is needed to remove the rear caliper mount bolts on a 2002 Chevy Suburban?
if it is the same as the 2004 then you would be looking for a 14mm or a 9/16 size
What size Allen wrench to remove a caliper on a 1988 Chevy Nova?
3/8
What size is caliper bolts on 95 Chevy Blazer?
A 3/8" Allen wrench is used to r&r the caliper bolts.
What size bolt is on the caliper of a 2001 Chevy blazer?
It takes a 3/8" allen wrench to r & r that caliper bolt.
