Usually just ethylene or propylene glycol.
"Like dissolves like" basically means that the substances can dissolve in one another because they are either charged or polar. Hope this helps!
Clean it out!! water will not hurt an alternator but Antifreeze will breakdown the varnish on the Stator windings! Oils is bad but Antifreeze is worse.
If it gets cold enough the coolant will freeze and crack the block if there is no antifreeze.
vehicle will overheat. just dump the oil and antifreeze , flush engine and refill with clean oil
It is possible that the antifreeze is coming from a bad water pump. Clean the engine off. Watch it to see where the antifreeze is leaking from, as it could be a hose instead of the pump.
No, polar solutes are generally not soluble in nonpolar solvents.
Generally polar solutes are dissolved in polar solvents and nonpolar solutes are dissolved in nonpolar solvents.
Generally polar solutes are dissolved in polar solvents and nonpolar solutes are dissolved in nonpolar solvents.
Solutes are substances dissolved in a solvent.
The term that summarizes the dissolving process of polar or nonpolar solvents and solutes is "like dissolves like." This means that polar solvents tend to dissolve polar solutes, while nonpolar solvents dissolve nonpolar solutes due to their similar intermolecular forces.
putangina
solutions
Example: polar solutes are dissolved in polar solvents, nonpolar solutes are dissolved in nonpolar solvents; this is a general rule but not absolute.
Solutions are mixtures of solutes (substances being dissolved) in solvents (substances doing the dissolving). Solutes dissolve in solvents to form a homogeneous mixture where solutes are uniformly distributed in the solvent. The amount of solute that can dissolve in a solvent is determined by factors like temperature and pressure.
Nernst's distribution law is applicable for the partitioning of solutes between two immiscible solvents at equilibrium, where the solutes exist in only two forms (unionized and ionized). The solvents must not react with the solutes, and the temperature must remain constant throughout the process. Additionally, the solutes should not form complexes with the solvents.
water
They can change by lowering the freezing point.