The Illeocecal valve
The heart beat, also called heart sounds, is produced by the closing of the valves. The valves produce two sounds, known as lub-dub. The atrioventricular valve closing produces the first sound, or lub, and the semilunar valve closing produces the second sound, or dub.
The closing of the mitral and tricuspid valves results in the first heart sound. The closing of the aortic and pulmonic valves results in the second heart sound.AV valve
The Mitral Valve is positioned between the left atrium and the left ventricle. Closing of the mitral valve prevents the blood from flowing back to the left atrium.
From the closure of the two flaps of the mitral valve in the left ventricle
EGR valves are usually activated by a vacuum line from a thermal sensor. It could be leaks in the vacuum lines, a failure of the sensor, or a failure of the valve itself. Since the valve is exposed to the heat of the exhaust system, it is prone to jamming from carbon buildup and destruction of the vacuum diaphragm from heat.
the diaphragm valve was developed during the 1940s.
by closing down the diaphragm
The Ileocecal valve
An iris diaphragm controls the amount of light admitted to a lens. Closing the iris diaphragm will decrease the brightness and increase the contrast of an image.
By closing the iris diaphragm, it closes the peripheral light so you can get a better image.
No, you should replace the valve.
result of an involuntary, spasmodic contraction of the diaphragm followed by the closing of
what
High Closing Ratio
Faulty diaphragm in the quick release valve.
A muscular valve is like a strong flap that is capable of opening and closing at will. An example of a muscular valve is the pyloric sphincter.
The regulator has an inlet and outlet. There is a valve at the inlet typically called a seat valve or similar. This seat is linked to a diaphragm. This diaphragm separates the upper and lower halves of the regulator body and also serves as the gasket for the two halves. On top of the diaphragm is a spring, below is the inlet seat. When no appliances are in use the lower section fills with gas, pushes the diaphragm up which seats the inlet valve and stops gas flow into the regulator. When an appliance is turned on, the gas flows out of the regulator and down the pipe to the appliance. When this happens the diaphragm lowers, opens the seat valve and gas once again flows. The seat valve has an orifice to reduce the speed at which the upstream gas enters the regulator, and the diaphragm spring determines how much pressure it takes to close the seat.