answersLogoWhite

0

What else can I help you with?

Related Questions

1993 Grand Am engine cranks but does not start No spark No power to instrument panel gauges when key is in the on position?

ignition starter switch


How do you reset the change oil light in a 1993 Chevy Corvette?

Turn the key to the Run position, but do not start the engine. Press and release the ENG MET on the trip monitor. Within five seconds, press and release it again. Within five seconds press and HOLD the GAUGES button on the trip monitor. The CHANGE OIL light will start to flash. Hold GAUGES botton until flashing stops. Light is now reset.


Check gauges light on Chevrolet astro van stays on?

gage of temperature go to hot position but is not hot the engine check gages light come on


Why does oil needle keep jumping and check gauges light keeps flashing?

Oil pump needs replaced.Oil is not traveling through vehicle when pump is bad. Oil pressure sensor needs replaced if check engine light comes on.


Why did the check gauges light come on?

The check gauges light comes on when one of the gauges is out of its safe range. It could be the alternator over or under charging, oil pressure low, or the engine overheating.The check gauges light comes on when one of the gauges is out of its safe range. It could be the alternator over or under charging, oil pressure low, or the engine overheating.


Is check gauges the same as check engine light?

No.


Reset oil change light 1995 corvette?

According to the service manual... -Turn key to the on position with the engine off. -Press ENG MET button on the trip monitor and release, then press and release again within 5 seconds. -Within 5 seconds of step 2, press and hold GAUGES button on trip monitor. Change oil lamp will flash -Hold GAUGES button until Change Oil lamp stops flashing and goes out. -When light goes out, the engine oil life monitor is reset. If it does not reset, turn ignition switch off and repeat procedure. -BewstAdd1ct


What to do to fix check gauges light?

When the check gauges light comes on it is telling you to check the gauges because at least one of the gauges is out of normal range. It could be low oil pressure, engine over heating or low voltage.


Can I put any gauges in your Jeep Cherokee?

You can get gauges with instructions at auto parts stores Oil Pressure, engine temp, amps or volts


How turn the check gauges light of?

The check gauges light comes one when one of the gauges is not in the safe range. It could be an engine overheat, low oil pressure, or the alternator over/under charging.


How do you check the gauges on a poniac sunfire 2 door?

To check the gauges on a Pontiac Sunfire 2-door, first, ensure the ignition is in the "On" position without starting the engine. Observe the dashboard for the speedometer, fuel gauge, temperature gauge, and warning lights, which should illuminate briefly. Check that the fuel gauge reflects the actual fuel level and the temperature gauge shows a normal reading once the engine is running. If any gauges are malfunctioning or warning lights remain illuminated, further inspection may be needed.


What is a gauges on the dashboard of car?

Gauges on a car's dashboard are instruments that provide vital information about the vehicle's performance and status. Common gauges include the speedometer, which shows the vehicle's speed, the tachometer, which indicates engine RPM, and the fuel gauge, which displays the amount of fuel remaining. Additional gauges may monitor engine temperature, oil pressure, and battery voltage. Together, these gauges help drivers maintain optimal vehicle operation and ensure safety.