Kilz Original does have a characteristic smell for about 1-2 days after applying it. You are referring to the oil based version of Kilz, which is the best KILZ primer to use for stains, smells, and applying over old surfaces.
I had to remodel my entire kitchen last year after a 25 year old Kitchen Aid dishwasher malfunctioned and burned up and spread water and soaked my entire kitchen. I had to deal with the insurance company for over ten months with just wanting to remediate the problem.
I won my appeal with them and ripped our the entire old kitchen down to the floorboard. I treated the floorboards with 2 coats of KILZ and then ripped out the wallboard, kilzed the exposed area, put in new insulation, added green board back in and Kilzed that before texturing and painting it.
KILZ is an amazing product. You do have to put up with the smell and I would use a fan and let the area get a good airing out.
I find that when it has cured and I have applied new paint over it, I get the NEW smell and I know that my walls and floor boards are protected.
An added note on putting KILZ on floorboards is that, in my opinion, it seals the floor from smells and also goes into cracks and exposed areas causing it to seal. Also, I like to say that it "tames" the floorboard because the oil based properties of this paint cause the wood to seal down and not splinter. Also, it insure that whatever you put over it is going to be sealed properly.
In my house, I kilzed the kitchem dining room, and hallways before adding hardibacker and putting in travertine flooring. Also, I kilzed my sons room and the living room before putting in bamboo flooring.
Recently, I had to rebuild the laundry room and after finding a rats nest in the wall, made sure to Kilz the area thoroughly with multiple coats after using a shop vac to get all the nasties out. I also replaced the wall board with GREEN BOARD and KILZED it thoroughly before texturing the wall. The new wallboard sucks up a lot of the KILZ and you will go through a few gallons but the lasting benefits of knowing that wallboard is sealed gives a lasting peace of mind.
I also believe that new insulation will last longer if the area where it is going to be placed is protected with a coat or two of KILZ. Remember, KILZ seals so that means that nothing is going to get in and oxidize the insulation prematurely.
I hope this helps you and I also need to say that if I had a choice between the oil based Kilz primer and the water based Kilz primer, I would choose the OIL BASED every time and put up with that kersosene smell you refer to in your original question.
It is just a small inconvenience to pay for years and years of protection that the oil based KILZ product insures you when you apply it to your walls, floors and all areas that need protection, sealing, and primering.
Also, every contractor that has come through my house and has learned how I do things nods and affirms that I am doing it right. When the city official came to sign off on my permits he was also equally amazed at the attention to detail I took to getting the job done.
I have KILZ to thank for that!
-Ken Graham
Napa, CA
yes... if they are in or around the room you are using the computer in
I am sure that there is at least one person not using their Shinedown password, but I doubt they'd let you have it.
You should not use kerosene to thin any paint. It will not mix with water based paints, and it is too dirty for use in oil based paint as an effective thinner. When using oil-based paints, Mineral Spirits is the preferred thinner for brushing and cleanup, while VM&P Naphtha is used for spray applications.
If it gets cold enough the coolant will freeze and crack the block if there is no antifreeze.
David Schlapobersky and Felicity Potter use both stoneware and porcelain clay. All their pottery is hand-made and decorated and then fired to cone 12, about 1320 degrees C in a reduction atmosphere using paraffin, kerosene, as their fuel.
To remove dye from kerosene, you can try using activated charcoal or a filtration process. Activated charcoal has a strong adsorption capacity that can help remove impurities such as dye from the kerosene. Alternatively, you can filter the kerosene through a series of fine filters to remove the dye particles.
Not sure what "TSP" is but these parts cleaners are designed for diesel or kerosene
To start a kerosene fire, you'll need to pour kerosene onto a fire-safe surface, form a small mound, and create a small depression in the center. Light the kerosene at the depression point using a match or lighter, ensuring you follow all safety precautions and regulations for starting and maintaining fires.
No, it is not safe to use acetone in a kerosene heater. Acetone is a highly flammable liquid that can ignite easily and produce harmful fumes when burned. Kerosene heaters are designed to burn kerosene, which has specific properties that make it suitable for use in these heaters. Using acetone in a kerosene heater can pose serious safety risks and should be avoided.
Give it a bath - using cat shampoo.
using organic substances like kerosene or alcohol
Yes, kerosene can kill grass if applied directly to it. Kerosene is a flammable liquid that can leach into the soil and harm plant roots, preventing the grass from growing. It is important to avoid using kerosene near grass or other plants to prevent damage.
No, breathing and smelling are not the same thing. Breathing is the process of taking air into and out of the lungs to facilitate respiration, while smelling is the process of detecting and recognizing scents using the nose and olfactory system.
Exposure to kerosene has not been conclusively linked to causing leukemia. However, there are studies suggesting a potential link between exposure to certain chemicals found in kerosene and an increased risk of leukemia, further research is needed to establish a definitive connection between kerosene and leukemia. Precautionary measures such as avoiding prolonged exposure to kerosene fumes and ensuring proper ventilation when using it are recommended.
we should not use any hot flames like a kerosene lamp, kerosene stove or electric heater near the gas cylinder.
Kerosene are good for cooking and heating up food. In the past, they are used for oil lamps because they are flammable. But, nowadays, they are used as jet engines and factories.
by old designed using styrofoam,adjustable kerosene lamp,thermometer