Impossible to say. You need to have the ECU scanned with a scan tool. The tool will retrieve the code that has been set. That code will help to find the problem if you know what you are doing.
symptoms of a bad sensor will be , engine cutting out then starting again as you drive. cutting out then being able to restart when vehicle is stopped. hard starting. if left long enuff before replacing, you will not be able to restart
Check the MAP sensor.
Maybe you need to check the oil The oil light will stay on until the engine starts. If the oil light was on when it was running and now it will not start then you may have internal engine damage. Take it to a professional.
You should check to see if the crankshaft sensor wires are connected correctly or at all. If they are , check that the cam sensor wires are conected and also make sure all your ground wires are corrosion free and tight. If the engine turns over but will not start check all fuses and make sure you have fuel (I know,but it happens) If it still won't start, hook up a timing light while a friend turns the key. If you get no flash could be a bad coil pack or coil connector could be corroded.
You may have knocked off a wire when you reconnected the starter wire, Check the wire going to the O2 sensor. if this isn't it take it to a shop and have them scan the ecm. It could be a flewk.good luck....Michael
Check the crankshaft sensor. The sensor connector could be loose or the sensor could be bad. Try to read the engine codes to see if the computer shows an issue.
symptoms of a bad sensor will be , engine cutting out then starting again as you drive. cutting out then being able to restart when vehicle is stopped. hard starting. if left long enuff before replacing, you will not be able to restart
no it can't. usually when the oxygen sensors are failing, u get your check engine light on.
Check engine light, rough running engine, no start at all.
Check engine light on, no start, hard start, die off.
when the engine is hot the check engine light came on and the fan(is ok) don't start
yes but it wont run so good and the "check engine" light will illuminate.
The car will start and run poorly in the limp mode and the check engine light will illuminate.
The check engine light will come on anytime the ECU detects a problem with the emission system. It should also come on when you start the vehicle and stay for a few seconds and then go out.
crank sensor will cause car to no start cam sensor will only set check engine light kbutlrtech@yahoo.com
If your check engine light is on replace your camshaft sensor if your check engine light isn't on it could mean theres a fuel problem you may have a clogged injector or a fuel pump going bad
Probably need to check the crank sensor (if the check engine light is on) or the fuel pump... I had that problem not too long ago...