above the rear end on the drivers side
what kind of solenoid a shift or pressure control??
The 2003 Kia purge valve solenoid is located on the firewall in the engine compartment. The purge valve solenoid will be on the passenger side of the firewall.
It depends on which solenoid you mean. The STARTERsolenoid is integral to the starter.
You can start by looking at GreatLakesXJ.com/tech.html. Be sure to give a donation so they can keep their wonderful document library open. You'll find the factory manual and parts catalogs there.
The overdrive solenoid on the 1984 Celica GT is located inside the transfer case valve body. The solenoid can be accessed by removing the transfer case pan.
It is located on the firewall above the back of the valve cover on the driver's side of the engine. It is mounted with a rubber and slides up and off the mounting bracket.
its under the hood on the passanger side on thefender wall its a 2 in cilinder piece attacher to a rather large hoes
It is mounted to the frame of the truck just in front of the fuel tank.
The evaporative emissions (EVAP) canister purge solenoid on a 2003 Chevrolet Silverado 1500 with a 4.8 liter engine is located behind the throttle body, near the front of the engine. I have a picture of it that I could send to your email if you want.
In the 2001 Toyota Corolla the evap purge solenoid valve is located near the underside of the air cleaner. This is an emissions control device.
The leak detection pump failing seems to be an issue on these cars. It is located near the fuel tank. It could also be the purge solenoid, located under the air filter housing.
On a 2001 Chevy Cavalier, the evaporative emission canister purge solenoid valve is typically located near the engine, mounted on or near the intake manifold. It is connected to the evaporative emissions canister by vacuum hoses. You may need to remove some engine covers or components for better access to the valve. Always refer to a repair manual or service guide for precise location and instructions.
First you have to remove the air filter housing, to see the carbon canister with hoses. The canister is oval, from top view. There are two evaporative emissions devices that connect to this canister. One is the Purge Valve Sensor, it is like a one inch black box with wire connectors and two connectors for tube on top. The other is the evaporative emissiong purge soleniod. It is usually a white plastic cylinder, about 2 inches long and also with two connectors for tubing. Make sure you make note of the correct direction of the two tubes when replacing or cleaning. The solenoid will show an arrow indicating direction to motor.
What does the solenoid control?
You need to clarify your question as to what you are referring such as engine or evaporative system.
Not sure what pressure control solenoid is, could it be the fuel pressure regulator?
The evaporative emissions purge control valve on a 1997 Chevrolet Astro van is typically located near the engine, specifically on the intake manifold or near the throttle body. It is connected to the charcoal canister and the intake system. To access it, you may need to lift the engine cover or remove some components for better visibility. Always refer to a repair manual for detailed diagrams and instructions specific to your vehicle.