The IAT sensor (Intake Air Temperature) is an integral part of the Mass Air Flow sensor.If the IAT sensor must be replaced,you must replace the MAF sensor
It is a sensor with 2 wires going into it located between air filter and throttle body.
here is a picture http://www.allfordmustangs.com/forums/attachments/5-0l-tech/40594d1204489550-location-1992-mustang-5-0-fuel-pump-relay-1992mustang-gt-5.0-001.jpg it is located under the hood attached to the passanger side wheel well. It is on the side closest to the front of the car.
Click on the link below Click on Owner Guides The owners manual ( which includes the fuse diagrams ) can be viewed online
change the fuel filter.if you ran out of gas you picked up crud from bottom of fuel tank
There may be no specific flat rate time for a repair like that, the cost will vary depending on the labor rate and how much time the technician takes to perform repair.
It's built into the Mass Air Flow sensor.
The IAT sensor is located is an intergral part of the the Mass Air Flow (MAF) sensor
i have mustang 1999 super charger i need intal performance chip in iat sensor wewr are this sensor
Its built into the Mass Air Meter
where is the intake air charge temp. sensor on a 1991 ford 5.0 coupe mustang
In the plastic intake tube between the air filter box and the throttle body.
The MAF sensor is mounted on the side of the air filter housing.
The 2007 Ford Mustang GT towing capacity is 1000 LBS
The axle ratio on a 2007 Ford Mustang GT is 3.55:1
I'll place my bet on the '07 GT!!
Bank 1 is the passenger side of the engine in your Ford Mustang Sensor 1 is in the exhaust BEFORE the catalytic converter ( upstream ) Sensor 2 is in the exhaust AFTER the catalytic converter ( downstream )
In the intake. (Intake Air Temperature)