answersLogoWhite

0


Best Answer

It is located on the timing chain cover.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the location of the crank position sensor on a 97 Lincoln town car?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Does a 1993 Ford Aerostar Van have a crank position sensor?

It appears that the Ford Aerostar with 3.0 engine does not have a crank position sensor, but the 4.0 engine does have one.


Can the crank position sensor be bad even though it checks out good with an OHM meter?

Yes, but not usually. If the computer is telling you that you have a bad crank position sensor, it could also be a connector or damaged wire. Don't be too literal.


How do you repair the crank signal so that the engine will continue to run?

replace cam position sensor


What is the difference between a crankshaft position sensor and a camshaft position sensor in a 1995 camry?

The Crankshaft sensor and the Cam sensor monitor the position and or the speed of rotation of the crankshaft. Together they send signals to the ECM. The ECM uses that information along with info from other sensors to send spark and fuel to the cylinders at the correct time. Some engines only have only a crank sensor to perform that job. Other engines that have both crank and cam sensors that split the duties.


Where is the O2 sensor and crank sensor located on a 91 Chevy Lumina 31L and is it fairly simple to replace yourself?

I have a 92 lumina with a 3.1 and I found the crank sensor to be located on the passenger side of the engine in the back of the engine NOT on the side of the engine below the knock sensor. Hello, in my experience, all O2 sensors are located in the exhaust just after the manifold. It appears easy enough to change. If it is the crank position sensor you are looking for, take a look around the main pulley at the bottom of the engine, you may see a square-ish component located close to the actual pulley wheel, this would be the crank position sensor, it should have wires connected to it.

Related questions

What is the location of the crank position sensor on a 1990 Firebird 3.1?

it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap


Location of crank shaft position sensor of a Nissan Altima 2.5 04?

Location of crank shaft position sensor of a Nissan altima 2.5 2004? send diagram please


Where is the crank sensor located on a Lincoln ls v6 engine?

where is the crankshaft sensor location on a lincoln ls v6 2003


Diagram of a crank position sensor in a 2002 Nissan Frontier?

location of a crank shaft sensor on a nissan frontier 2002


Where is the location of crank shaft position sensor on a Nissan Pulsar N16 2000 model?

Can you please tell me where the location of the Crank Shaft Position Sensor is on a Nissan Pulsar N16 2000 model?


Where is the location of crank position sensor on 2004 Chevy silverado?

behind the starter


Where is the Location of the crank position sensor for 1994 Corsica 3.1?

its locted by the crank pulley the ower pully on the car


Crank position sencer location on 2003 Pontiac GTP?

The crank sensor is located behind the hamonic balancer


On a 1994 ford ranger the crank position sensor it brakes the magnet off the sensor and there is not enough adjustment to stop it how can you stop that?

On a 4.0 V-6 the crank position sensor is in a fixed location and cannot come in contact with the crank if it is installed correctly.


Where is Location of crank position sensor 1999 BMW 528i?

Located next to the crankshaft pulley


Where is the crank position sensor for a 95 blazer?

Where is the crank position sensor hole on a 2003 Blazer


Is the throttle position sensor and crank position sensor the same thing?

No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.