underneth the intake underneth the intake
replace head gasket
You can find pictures of oil pumps at most Ford automobile dealerships. Many auto-parts websites will also have pictures of Ford oil pumps.
the oil pressure sending unit is designed to warn you of a low oil pressure. If the sensor goes bad then the low pressure light or gauge will read low when the oil pressure is actually ok.
For the 3.0 engine it is 4.5 quarts.
Yes! Remove whatever is necessary to allow you to remove the oil pan.
For a 1994 Ford Ranger , 3.0 liter V6 engine : ( 5W-30 is the PREFERRED oil )
Can the oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?
the PCV is mounted in the oil separator on the left side of the engine
For a 1994 Ford Ranger , 4.0L V6 engine : The PREFERRED oil is 5W-30 With engine oil filter change ( 5.0 U.S. quarts / 4.7 litres )
It should be located in the oil pan. On my ranger its on the drivers side.
oil sensor on your oil pan is bad.
4 or 5 quarts
on an SOCH 4 cyl its mounted in the oil separator on the left side of the engine on an DOCH you have to remove the drivers side inner fender well to get to it
With engine oil filter change ( 5 quarts )
There is no such thing as an oil pressure switch on your 1994 Ford Ranger 3.0 liter engine. There is an oil pressure sensor. The oil pressure sensor can be found on the left-hand side of the engine.
on an SOCH 4 cyl its mounted in the oil separator on the left side of the engine on an DOCH you have to remove the drivers side inner fender well to get to it
In a 1994 Ford Ranger , V6 : NO , 5W-30 is actually the PREFERRED oil ( I have been using 5W-30 in my 1995 Ford EXPLORER , 4.0 liter EFI , V6 engine for over 18 years now )