Is it gasoline or diesel? If it is diesel, it is in the passenger side of the motor up by where the transmission mounts. It is held by three screws which can be a little tricky to get in and out since it is in a rather cramped space. It took me a little over an hour to change mine out. Since I do not have the gasoline engine, I can't say for sure about where the starter is on that make, but I would figure it would be in around the same location close to the flywheel.
FIRST CRAWL UNDER THE PASSENGER SIDE OF THE TRUCK AND LOOK UP TO FIND THE STARTER,ONCE YOU FIND IT,REMOVE THE BIG RED CABLE,AND THEN REMOVE THE SOLENOID WIRE, REACH UP AND FIND THE TOP BOLT,LOOSEN THAT ONE FIRST,THEN HEAD TO THE RIGHT ONE,THEN TO THE LEFT ONE.PULL OUT THE STARTER,THEN MAKE SURE WHERE THE STARTER IS MOUNTED IS CLEANER THAN A BABY'S BOTTOM OR WHEN U GO TO START THE TRUCK IT WON'T START....REMEMBER THIS,AND INSTALL REVERSE OF REMOVAL!!
The Amperage draw is so high it locks the starter solenoid. This can be because of a bad starter bushing, low voltage in the battery, timing, etc. It is a major engineering defect in the design. All Fords prior to 1992 have this flaw. It can result in a fire, dead battery, etc. The good news is Ford redesigned their starters in 1992. The new starters will fit the old engines and Ford sells a retrofit kit to rewire the Solenoid for the new starter. The way it corrects the problem is the old solenoid becomes a starter relay, with the output wire now going to a solenoid mounted on the new starter. (This gives you less of a voltage drop at the new solenoid vs the old solenoid, that solves the problem in most cases) You need to buy the kit from Ford (Under $20.00) but you can buy the starter anywhere. Just give them your vehicle information as if you owned a 1993 Ford when buying the starter. You can also get a rebuilt starter from Ford. You could make your own kit, but the Ford Kit is everything you need and comes with instructions (priceless). Warprunner
F350 is a Ford. Why is fuel getting into the crankcase? Dead cylinder and it is running past the rings. If that's not your question, rephrase it and ask again.
does cooling system hold pressure?
Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Ford starter.
how can i delete a egr vavle on 1997 ford f350 with electronic fuel injection, its a7.5 gas 460
No because they are 2 compleatly diffrent body styles
yes
There are five models of the Ford f350 Dually. These models were released consecutively each year by Ford company. Each of them has different specifications.
only if the f250 is a dually to but otherwise no because the front and rear wheels are offset on the dually
Your answer is NO... The F550 & F450 use a 10 bolt patern and the F250 & F350 use an 8 bolt patern.
A 2002 f350 drw is 7.5 feet wide.
Disc
The towing capacity of a 2001 Ford F350 dually diesel 4x4 truck is 8,250 pounds. This allows the truck to safely transport all but the largest trailers and boats.
Ford F350 Super Duty Dually
no. a f350 bolt pattern is not the same to a f-450 bolt pattern because the f350 have 8 lug nuts and the f450 has 10 lug nuts
The Ford F350 is a full-sized, super duty truck. It is available with single rear wheels or as a dually. For more information, visit http://www.carsdirect.com/ford/f350.
original sticker price for a ford f350 1994 dually xlt