hi the thermostate is located at the rear of the engine you have to feel down the back of the engine under the intake manifold you can feela plastic pipe follow the pipe towards the cam covers you will feel 3 .8 mm bolts undo those 3rd one not easy but thermostate is fitted iin there make sure you buy thermostate with a pin fitted to it or you wont bleed the water systerm ok good luck Dave
in my opinion yes, i got my 75 rover a while back and it still works perfectly
under the rear seat on the drivers side on a v6 75
i have a rover 75, 1.8. it has about 26,000 miles on clock. when does my timing belt need changing
MOST LIKLY YOUR THERMOSTAT NEEDS CHANGING.
The crankshaft sensor on a Rover 200 is located below and to the right of the generator and cylinder head temperature sensor. It is on the driver's side of the engine and above the oil filter.
how do you replace a thermostat in a rover 25
Difficult to work on and lots of garages wouldn't touch mine which is a Rover 75 V6 auto. I got a garage to carry out repair for about
How do i time rover 75 v6 engine/
2004 Range Rover air supension inactive
where is it to start with.
To change the thermostat housing on a 2002 Rover 75 petrol, start by ensuring the engine is cool and disconnect the battery. Drain the coolant from the system, then remove any components obstructing access to the thermostat housing, such as the air intake or engine cover. Unscrew the housing bolts, carefully remove the old housing and thermostat, clean the mating surfaces, and then install the new thermostat and housing with a new gasket. Reassemble the components, refill the coolant, and reconnect the battery before starting the engine to check for leaks.
Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180 Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180
On the Rover 75 CDTi, the thermostat is located on the engine block, specifically in the vicinity of the cylinder head. To access it, you'll typically need to remove the engine cover and some other components, as it's not readily visible. It is usually situated near the water pump and connected to the cooling system hoses. Proper access may require the removal of the intake manifold or other components, depending on the specific setup.
yes
in my opinion yes, i got my 75 rover a while back and it still works perfectly
where is the parking buzzer located in the rover 75 .its somewere in the front but i cant find were as it has stoped working
where is the parking buzzer located in the rover 75 .its somewere in the front but i cant find were as it has stoped working