Mars is so far away in fact that it takes radio signals quite a long time to get from the spacecraft back to Earth. During Curiosity EDL, this delay will be 13 minutes, 48 seconds, about mid-way between the minimum delay of around 4 minutes and the maximum of around 24 minutes.
It depends on the settings. Things such as auto-focus, red-eye reduction, or backlighting can cause a delay while the image is defined.
Using a multi-bus architecture will really improve the speed and also increase the performance of your processor in execution of different instructions because using a multi- bus architecture will help in such a way that one device would be connected to one bus or less devices would be connected to one bus rather than in single bus architecture more devices would be attached to single bus. Hence, the delay in execution of instructions of the devices would be really less because in case of single bus architecture the delay is greater. How is that so ? Actually when an instruction is transferred by the bus to the processor from a specific device, the other devices wait for the bus to be free and transfer their instructions when the bus becomes free. Hence each device has to wait for the bus to be free and hence a delay comes in the execution of the instructions. Now in a multi bus architecture less devices are connected to a single bus hence the delay in the execution of instructions is less. Therefore, improving the speed of the execution of the program.
The combustion process of a compression ignition engine can be divided into: 1) The delay period (start of injection until first visible flame) 2) The rapid pressure rise period 3) The mechanically controlled burning period 4) The after-burning period
When the Greek force holding the pass against the Persian invasion was withdrawn after their mission of temporary delay was completed, the Spartans and Thespians remained behind to allow them to escape before the Persian cavalry broke out and rode them down the open country. They held the pass for an extra few hours to achieve this, selflessly sacrificing themselves for the other Greek city contingents.
In the center of the dash on the left side is a timer relay. it is probably bad, causing the delay part of the lights to not work.
Interior lights are controlled by the overhead console, Hit "Menu" until you reach the interior light delay, then press "STEP" to change.
A time delay relay is used in applications that have a need to be automatically switched on and off. A few applications that require time delay relays are strobe lights, stoplights, and Christmas tree lights.
I assume you talking about DRL lighting. No. That year Sable came with an automatic system which turn on all the lights when ambient light dropped and had a delay off timer when the car was switched off.
It's located behind the glove compartment in the light delay relay panel.
I've been trying to get a more detailed diagram for this but basically it is the relay that leaves the lights and windows on after you turn off the key but haven't opened the door. .
Delay if they do not go off after the delay time look for faults in the BCM
It could be two things your switch for the lights is still turned on or your lights are on a timer and shut off after a twenty second or so delay.
my 1999 has a slide control on the bottom of the interior rear view mirror all the way to the left turns the delay off and sliding the control right increases the amount of the delay
start off by checking all door switches. Then check the interior switch on the dashboard. I mean by checking as in bypassing switch or disconntection of the switch. If you have the theater dimmer or the delay dimmers you would check that also.. Thanx Dom
Nothing, it is EDSAC not ESDAC. Electronic Delay Storage Automatic Calculator. The delay storage part of the name referred to its use of mercury acoustic wave delay lines for memory store.
They must share a common thread, maybe a bad circuit breaker or fuseable link.