It hasn't got one. Instead, it has a fill hole with a plug that you remove to fill or check the fluid level. The fluid should be about 1/8th inch below the hole, but right up to the hole is still safe. Do not accidentally drain the trans.
Mopar® Manual Transmission Lubricant is recommended or equivalent for use in the manual transmissions
It is a 5 speed manual transmission that is operated/shifted by means of a hydraulic operated clutch.
it is a manual 5 speed tranny.
The 1999 Chevrolet Suburban speed sensor is located on the back of the transmission. The speed sensor will be in the upper left-hand corner.
The 2010 Smart Fortwo has a 5-speed automated manual.
The 2002 Chevrolet blazer speed sensor is located on the side of the transmission. The speed sensor will be on the right hand side of the transmission.
In most cases, you will find the speed shift sensor for your 1998 Chevy Blazer located on the backside of your transfer case. The transfer case is located on the transmission.
There are 4 different options for the type of transmission that came in a 1988 K5 Blazer. They are the 4 speed SM465 manual, the 3 speed TH350 automatic, the 3 speed TH400 automatic and the 4 speed 700R4 automatic.
The speed sensor is located on the transmission on tail shaft behind the transfer case
The vehicle speed sensor is located at the top of the transmission tail shaft housing.
A manual transmission doesn't have a dipstick
The maximum speed of the 1975 Chevrolet Blazer manual 8cyl 163hp is 100 mph.
Where is the idle speed motor located at on a 1995 chevy blazer?
The approximate maximum speed of the 1974 Chevrolet blazer manual 6cyl 100hp is 85 mph.
* 30RH-Automatic Transmission 3 Speed * 32RH-Automatic Transmission 3 Speed * 3550-Manual Transmission 5 Speed * AISIN-Manual Transmission 5 Speed
It depends on if its 4x4 or 2x4. On the 2x4 version its located on the rear of the transmission. If its 4x4 it is located on the transfer case.
If you have the owners' manual, check it. If not, the 1992 Rangers' Mazda 5-speed manual transmission called for MERCON ATF..yes that's correct; Automatic Transmission fluid goes in the manual transmission. You can fill it through the Hex- bolt hole located on the driver's side of the unit near the middle.