A flashing engine light is usually a misfire.
No, the check engine light does not come on because your gas is half way full. The check engine light will come on if there is a problem with the engine.
no a burnt out headlight will not cause a check engine light but if you go to most of the part places they will check the check engine light for free
Check all of your turn signal bulbs. One of them may be burned out.
Engine off turn key forward until lights go on. On the firewall in the corner by the driver is a blinker box. carefully remove the top press the button and hold for 5 seconds the light should come on. release and repeat .the light should go off. the codes are erased now. To check start car or put the pigtail into hole two. press button for three seconds and release. the red light will blink the code 111 is no codes.
the below is faulty;#2 answer 1: AZ can not scan any suzuki below 1996 period. only factory scan tools can do that. $4000 tool + but the OD light means the transmission computer has stored error codes. this puter is called a TCM for the 4speed electronic automatic tranny. http://www.kick-fix.com/Blink.html this car has 3 ways to blink lights. ECU TCM and brake RWAL controller. each one has a jumper connection and the manuals in stores do not cover them all. my link shows how to do all of them. The check engine lamp, just jumper the DLC connector diagnostic request pins. it will blink out an error. (the ECU talks to the tranny TCM) and can set the ECU DTC for the tranny too. DTC = diagnostic trouble code. all you need is a paper clip for a tool , nothing else. answer 2 (old) A blinking overdrive light and the check engine light on most likely indicate the transmission range sensor (TRS). For detailed info, have the vehicle scanned at a local auto parts store (AutoZone, etc,) that offers free scans. If you want to retrieve the codes yourself, go to your local public library and check out a repair manusl (Haynes or Chilton) for your vehicle. Detailed instructions on how to retrieve the trouble codes and what each code means are in chapter six.
With a scan tool, or try turning key on, off, on, off, on and counting the blinks of the check engine light. blink, blink, blink, pause, blink would be 31.
A flashing check engine light is usually an indication of a misfire.
On some if you turn key on, off, on, off, on. The check engine light may start to flash the code. blink, blink, bink, pause blink would be 31.
If the check engine light does not flash when in the diag mode, the problem is the computer. Could be as simple as a failed lamp driver but a failed computer is toast and will need to be replaced/
Probably because you need to check the engine.
If the check engine light is blinking , an engine cylinder misfire has been detected
An engine misfire has been detected
Check to see if your gas cap is tight.
It is indicating that there is a fault with the engine of the car. You need to take it to a garage for repair/service.
first you nee to check and see if your car is referred to as OBDI or OBDII if its ODBI then you start with the car off.. turn the key to run but do not start the engine.. at this point you have less that 5 seconds to push the gas pedall all the way to the floor and press the overdrive button five times... then the check engine light will stay on.. and then blink... next its going to blink out the code for you for ex. blink-pause-blink blink-pause blink blink blink-pause blink n that would mean the problem code is 1231 just Google BMW problem codes and use that dcode to find out what the issue is..
If your check engine light is blinking , that means a cylinder misfire has been detected
That is the check engine light. It blinks under a severe misfire.